Setting up some profender struts

[brad 93hilux]

Hey I am in the process of installing a 4" superior eng lift kit into the 120 series prado

I have profender remote reservoir adjustable struts and dobinson medium coils and due to the amount you need to compress the coil to assemble the strut I took it to pedders (didn't know where else to go) to have them fit it together.

I'm not confident they knew what they were doing and want to get them adjusted properly, can somone recommend a shop/place to take it to to get these setup properly either around Wollongong/south Sydney?

If not in a few weeks ill be leaving to go up to cape York and ill just go to superior eng workshop, but surely there is some people that can do it down here?

Cheers brad

[bazzle]

Prob need about 60 to 80psi of Nitrogen in them. You cant measure with a gauge as nearly all the gas will be used taking the reading.
You need a fitting that reads the line pressure as it puts it in and then you close the valve.

[Willy Hilux]

I'm sure if you bought them from Superior that they come pre gassed at there recommended pressure. The struts are adjustable so you can set the ride height. Just need a good flat screw driver and hammer I'm sure and make sure the two nuts are locked together.