Hey everyone
Now please don't burn me for this question I dont know a lot about diffs
Wondering can you say go from a 4.3 ratio to a 4.8 ratio and use the same locker or does the locker suit the ratio?
Thanks
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
air locker question
Moderators: toaddog, TWISTY, V8Patrol, Moderators
Re: air locker question
Yes..
1993 80 series, 4" tough dog adjustable bb lift kit, LPG, 35" MTR'S
brooksy wrote:Branden Tagg.....He is the King of all f@rkups & a Gimps bitch after hours
Re: air locker question
yes you can change ratio from 4.3 to 4.8 and keep the same locker.stilivn wrote:Yes..
03 HDJ100R GXL / 94 FJ45-80
Re: air locker question
Qualify that.
Yes, mostly.
Some vehicles and diffs, ie Dana salisbury type have two different offset centre carriers. As you go shorter in gear rations (ie higher numbers, 3.9, 4.1, 4.56, 4.88 etc) the pinion gear gets smaller, and hence the crown gear (Crownwheel) is thicker (as the pinion cannot be moved sideways to mesh with the crownwheel). Effectively the mating face of the crownwheel gear can only be moved to suit the pinion, so the gearset is thicker.
Up to a point, then a centre with a different offset is required. With some rations you can get thick or thin crownwheel gearsets to suit your centre carrier.
Hence ARB and Eaton/detriot etc all made several centres for the same diffs, depending on ratio application.
If not clear, I can find pics and post em.
Yes, mostly.
Some vehicles and diffs, ie Dana salisbury type have two different offset centre carriers. As you go shorter in gear rations (ie higher numbers, 3.9, 4.1, 4.56, 4.88 etc) the pinion gear gets smaller, and hence the crown gear (Crownwheel) is thicker (as the pinion cannot be moved sideways to mesh with the crownwheel). Effectively the mating face of the crownwheel gear can only be moved to suit the pinion, so the gearset is thicker.
Up to a point, then a centre with a different offset is required. With some rations you can get thick or thin crownwheel gearsets to suit your centre carrier.
Hence ARB and Eaton/detriot etc all made several centres for the same diffs, depending on ratio application.
If not clear, I can find pics and post em.
My friends aren't holding me back..... I'm pulling 'em forward.
Who is online
Users browsing this forum: No registered users and 144 guests