Air con fan has stopped working....
Can not find a fuse or an online wiring diagram ...
Any help with common issues or a wiring diagram for the fan before I pull things apart?
Peter
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
1990 NG air con / interior fan
Moderator: -Scott-
Re: 1990 NG air con / interior fan
Does the fan work on High setting only? If it does, it is the resistor which controls the fan speed. The resistor will be located in the underside of the fan casing and will have several wires going to it. You will get access to it from under the evaporator unit inside the cabin.
If the resistor bank is stuffed, the obvious place to look is a wrecker - a later model resistor bank would probably fit. If you are a real tightarse (like me, who enjoys a challenge), you can get some resistance wire and make your own resistor. It will probably be the first stage resistor (there will be 3 stages). The hardest bit is getting good contact because soldering resistance wire is a very hard job to do. From memory, the first resistor stage was about 3 ohms. The resistor coils protrude into teh fan housing and use the airflow to cool the resistors.
If the resistor bank is stuffed, the obvious place to look is a wrecker - a later model resistor bank would probably fit. If you are a real tightarse (like me, who enjoys a challenge), you can get some resistance wire and make your own resistor. It will probably be the first stage resistor (there will be 3 stages). The hardest bit is getting good contact because soldering resistance wire is a very hard job to do. From memory, the first resistor stage was about 3 ohms. The resistor coils protrude into teh fan housing and use the airflow to cool the resistors.
Re: 1990 NG air con / interior fan
Fan does not work on any speeds...
Have managed to find a wiring diagram today...
Have managed to find a wiring diagram today...
Who is online
Users browsing this forum: No registered users and 1 guest