My bottom sill doors and rear end of the lwb patrol (mq) is collecting water are there factory drainage points or do i need to drill holes
I already get water coming up from the sill to inside the car due to the door sill being on the outside how do i stop this happening (will drilling holes make this wores), are there sposed to be plugs in the tops of the sills
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
mq water dranage problems
on the MQ's and GQ's doors for that matter there are small drainage holes, these often fill up with dirt and shit and become clogged, this will cause it to trap watter, i had 3 doors with a good couple of litres in each just the other week, i used some wire and slid it up the holes which cleared em out,
to make sure they are clean take interior trim off and flush out with the hose.
to make sure they are clean take interior trim off and flush out with the hose.
God of Magnificant Ideas!
The doors have 2 groups of 6 or 7 drain holes in them, one group is about 5" from the front edge and the other group is about 5" from the rear edge. The holes are about 5/16 in diameter, some ppl intentially block these holes up for some stupid reason and thats where the problems start.
The sills have 2 drainage points which are small folds in the inner sill panel near the cab/chassis mounts, A small piece of wire poked into the holes should unblock them.
The rear 1/4 has 1 drainage point and is simmilar in style to the sill ones, again a piece of wire should unblock it.
Once all the drainage holes are unblocked, place a piece of electrical tape over all the holes and apply fishoil ( fisholene ) to the internal cavaties.... once it dries remove the tape and ya done !
Kingy
The sills have 2 drainage points which are small folds in the inner sill panel near the cab/chassis mounts, A small piece of wire poked into the holes should unblock them.
The rear 1/4 has 1 drainage point and is simmilar in style to the sill ones, again a piece of wire should unblock it.
Once all the drainage holes are unblocked, place a piece of electrical tape over all the holes and apply fishoil ( fisholene ) to the internal cavaties.... once it dries remove the tape and ya done !
Kingy
[color=blue][size=150][b]And your cry-baby, whinyassed opinion would be.....? [/b][/size][/color]
Who is online
Users browsing this forum: No registered users and 1 guest