Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

dizzy and oil pan......

Tech Talk for Ford, Mazda, Daihatsu & Makes that currently dont have a home.

Moderator: Tiny

Forum rules
Post Reply
Posts: 2431
Joined: Thu Sep 04, 2003 12:02 pm
Location: Stayton, Oregon, USA

dizzy and oil pan......

Post by SimplyPV »

hey fellas.. got a question.... since i slapped on my intake to the jap. applause engine... i've noticed that the dizzy on the applause motor doesnt have any of the vacuum hoses needed so i slapped on my orginal dizzy... is there anything i should know about? will it work? or have the engine run bad? what? if i need to put the other dizzy back on.. what do i do with the extra hoses coming off of the intake to the dizzy? also, i've looked at both oil pans and i am wondering. i should i swich oil pans? they both look really similar and it could work... unless someone can tell me i'm wrong. i want to do as little as possible. the gasket/seal on the new engine looks really good and i really dont want to mess with that unless i have to. any advice would be gratefully taken. thanks

pv
[quote="simplypv"]its a Strine thing and i just dont understand![/quote]
Regards, PV
Team [size=134][color=red][i]Anti-[/i][/color][/size]Asshat [b][color=orange]#5[/color][/b]- Yank!
Top
Posts: 3523
Joined: Sun May 18, 2003 8:42 pm
Location: Somewhere they can't reach me, shoot me or electrocute me...

Post by Area54 »

If it's a rubber seal, you can carefully remove it with no problems, just clean the surfaces well before reapplication, a bit of RTV sealant on the front and rear oil seal housing joins may be needed (not sure on the pan/block setup).
Built, not bought.
Top
Posts: 2431
Joined: Thu Sep 04, 2003 12:02 pm
Location: Stayton, Oregon, USA

Post by SimplyPV »

fellas... found a hole in my oil pan so its no good.. i need to know if i need to strip the one off of my parts truck back home and have it shipped (what i'm doing with the engine mount) or if i can use the applause pan.. pls let me know. thx.
[quote="simplypv"]its a Strine thing and i just dont understand![/quote]
Regards, PV
Team [size=134][color=red][i]Anti-[/i][/color][/size]Asshat [b][color=orange]#5[/color][/b]- Yank!
Top
Post Reply

Return to “Ford / Mazda / Daihatsu / Homeless”

Who is online

Users browsing this forum: No registered users and 0 guests