GU winch bar

Post by **haycait** » Mon Jul 12, 2004 7:45 pm

Hello for the first time,
I am a long time reader and first time writer to this forum. (sounds tacky even as I type it)

I cruise around the place in a GU Ti which is pretty stock at present but I plan to change that slightly soon.

To start with I am planning to fit a steel winch bar. My problem is that the one I am looking at I am told is for a non flared GU. It is a Std nissan bar which is made by ARB. ARB list two bars for winch and non winch models

Can anyone tell me if there is actually a significant difference?

Thanx in advance
Cheers
Haycait

Post by **roly** » Mon Jul 12, 2004 8:06 pm

if its a non flare bullbar (DX) then it will look Grimace on a car with flares

Post by **haycait** » Mon Jul 12, 2004 8:30 pm

Thanx for the tip roly.

Whats the difference?

Is it just a bit narrower at the sides?

Post by **bazzle** » Tue Jul 13, 2004 8:22 am

Narrower at sides (wing length.)

Should fit ok esp if price is good.

Bazzle

Post by **haycait** » Tue Jul 13, 2004 9:36 am

bazzle wrote:Narrower at sides (wing length.)

Should fit ok esp if price is good.

Bazzle

Price is verrrrry good

I will write the price on the front of the bar so when I look at it I remind myself :cool:

Cheers
Haycait

Post by **roly** » Tue Jul 13, 2004 10:33 am

is this the $700 one on overlander?

Post by **haycait** » Tue Jul 13, 2004 12:08 pm

roly wrote:is this the $700 one on overlander?

No even better than that

I picked it up for $500 elsewhere. Same bar less $$$

So the one on Overlander is still available for $750 if anyone else is interested.

Outer Limits 4x4 Board

GU winch bar

GU winch bar

Who is online