Toyota 100/80 -5 stud

Post by **Dozoor** » Fri Jul 30, 2004 9:07 pm

Any body know the Pcd on the 100/80 series 16x8 5 stud steel rims ?

its a bigger circle than the 6 stud which is 6 on 5-1/2 i think.

Post by **dumbdunce** » Fri Jul 30, 2004 9:56 pm

150mm - it's only 78/79/100/105 series, 80 series in 6 on 140 (5.5") same as patrol and earlier cruisers.

Post by **Dozoor** » Fri Jul 30, 2004 10:52 pm

Thanks DD ,

I thought they where larger just not quiet enough hehe-

wonder if the studs are 8 mm or 10mm,

Just toying , wouldn,t mind a set of 16x 8s for my project , for my silverstones , Rover axles so the pcd 5 on 165 -

The rover uses around a 15 mm stud --

That leaves 5mm of the existing hole mmmm.........

pretty easy to get the five stud ones .

Post by **dumbdunce** » Fri Jul 30, 2004 11:06 pm

Dozoor wrote:
wonder if the studs are 8 mm or 10mm,

Just toying , wouldn,t mind a set of 16x 8s for my project , for my silverstones , Rover axles so the pcd 5 on 165 -

The rover uses around a 15 mm stud --

That leaves 5mm of the existing hole mmmm.........

pretty easy to get the five stud ones .

the rover steel wheels are pretty flat on the mounting flange aren't they? re-drill them for toyota 5 on 150mm rotated 36 degrees from the rover holes. most (all?) toyotas use 12x1.25mm studs.

Post by **Bush65** » Sat Jul 31, 2004 9:44 am

100 series wheel studs are 14mm
rangie wheel studs are 16mm

Outer Limits 4x4 Board

Toyota 100/80 -5 stud

Toyota 100/80 -5 stud

Who is online