speedwerx bender

[Eddywelder]

I am looking at buying one of these tube/pipe benders but want to know is anyone familiar with them or have used one....since it is hard to find a shop in sydney to do a few bends to build a cage for my rig I was thinking of buying one for myself as I am sure if I get one I can do my tube work and others out there will probably want some bending done too...any comments on other brand benders let us know...
thanks everyone....
Eddy

www.speedwerx.com.au

[RV80]

Get the speedwerx...

[sierrajim]

Any idea on how much they cost?

[spazbot]

what size tube do you need to bend ?????

have you asked overkill they have a bender and so does m&m
sufection on here has bender aswell.....
i know surfection can do up to 1 3/4" tube same for overkill i think, anything bigger than that i dont know

[Eddywelder]

2 inch or 50mm diameter is what I need bent and the speedwerx bender has that size die available though at $1300 for bender and die a bit pricey just for a one of job....

[antt]

for a cheap alternative, look at gettin a dawn bending die (about $100) to use with one of those cheapo pipe benders. i built my exo using it, and wendle built a whole tube buggy using one.

heaps on info about them in this thread-> http://www.outerlimits4x4.com/PHP_Modul ... nding+dawn

[bru21]

i got a speedwerx 2" & 11/2", and tube cutter about $2500 all up. its heaps bigger and better than it looks in the photo's. i think the bender was 700, the dies 600 and 500 cutter 400 roughly. why not buy it use it and sell it, might work out cheaper than gettin it done elsewhere

cheers bru

[N*A*M]

also i think big balls will rent their speedwerx ask Liam