Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

how the h3ll do i remove the flanges off my diff

Tech Talk for Nissan owners.

Moderators: toaddog, V8Patrol

Forum rules
Post Reply
Posts: 2820
Joined: Sun May 25, 2003 10:04 am
Location: Redbank Plains, QLD

how the h3ll do i remove the flanges off my diff

Post by Daisy »

How do i remove them??

Pinon flanges so i can change em over to the 4.2 ones. They got too much play in them to allow me to undo them - in relation to the tyres turning when i try to undo them.

Any ideas???

Have tried the big pipe over the ratchet to try to turn but ive a feelin ill need to use a air ratchet gun.... :(

Hope someone can help out..

TOM
Top
Posts: 2492
Joined: Sun Nov 24, 2002 8:57 pm
Location: Melbourne

Post by bazzle »

Air gun , long pipe on socket and bar. Youll prob break ratchet.
A flame will help loosen any loctite if youncant crack it. Just make it "psst: to touch. on end of flange

bazzle
Top
Posts: 625
Joined: Fri Feb 20, 2004 12:04 am
Location: Melbourne

Post by Woop »

A long thick piece of steel about 40mm wide x 1m long with holes drilled in it to match the holes in the flange is what i've been using. I use a 3/4 drive rachet to undo. You will need a torque wrench to tighten up to spec to mantain bearing pre-load though. I THINK its a 32mm nut.

Nick
Top
Post Reply

Return to “Nissan”

Who is online

Users browsing this forum: No registered users and 1 guest