My 86efi rangie has just started cranking over when the ignition is in the ON position. I can pull it into gear to stop it from cranking but if i put it back in park or neutral it starts cranking again.
Now it only does this ocasionaly not constantly. When it does this the Brake warning light also comes on and stays on which i think is normal when you turn the key to start but it also tells me when this problem is present before i put the auto back in park.
As far as i know the ignition switch has not long been replaced by Britswed before i bought it but im not sure if the Micro switch on the ignition was also replaced.
Hoping that someone else has had this problem and knows something about it.
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Why Does my Rangie crank over with the ignition ON?
Moderator: Micka
On a slightly different thread, if my Rangie stalls etc, I can never just crank it over! I've got to turn if off completly and turn it on again. Kind of sucks offroad as you run the risk of locking the steering etc while moving.
Just wondering if that's "normal" rangie behaviour or is my car special
Just wondering if that's "normal" rangie behaviour or is my car special
Timbot wrote:On a slightly different thread, if my Rangie stalls etc, I can never just crank it over! I've got to turn if off completly and turn it on again. Kind of sucks offroad as you run the risk of locking the steering etc while moving.
Just wondering if that's "normal" rangie behaviour or is my car special
i have to do that with mine too
Timbot wrote:On a slightly different thread, if my Rangie stalls etc, I can never just crank it over! I've got to turn if off completly and turn it on again. Kind of sucks offroad as you run the risk of locking the steering etc while moving.
Just wondering if that's "normal" rangie behaviour or is my car special
Every Euro car I've ever driven has done this.
Andrew.
Ruff,
Check the relay under the plastic cover pas side under bonnet, I believe the starter realy is there.
Other option is the solinoid on the starter.
Michael.
Check the relay under the plastic cover pas side under bonnet, I believe the starter realy is there.
Other option is the solinoid on the starter.
Michael.
Mitsubishi 2010 NT DID Pajero wagon, Factory rear diff lock, Dual batteries, ARB bar, winch, Mt ATZ 4 rib tyres.
1986 RR.
Custom suspension links etc.
HSV 215 engine.
4.3 diffs.
1986 RR.
Custom suspension links etc.
HSV 215 engine.
4.3 diffs.
HSV Rangie wrote:Ruff,
Check the relay under the plastic cover pas side under bonnet, I believe the starter realy is there.
Other option is the solinoid on the starter.
Michael.
Someone else also suggested this. You dont know which one it is by any chance do you?
Shouldnt be the Starter as its not very old.
RUFF wrote:HSV Rangie wrote:Ruff,
Check the relay under the plastic cover pas side under bonnet, I believe the starter realy is there.
Other option is the solinoid on the starter.
Michael.
Someone else also suggested this. You dont know which one it is by any chance do you?
Shouldnt be the Starter as its not very old.
I'll look it up tonight for you
Tom
Ok,
according to my red haynes manual ... if you pop plastic cover off the engine bay relays then you should see 7 relays all lined up together.
from left to right these are
1. Aircon Fan relay
2. aircon relay
3. compressor clutch relay
4. Fan relay
5. Starter solinoid relay
6. Heater rear window relay
7. Brake failure warning check relay.
Now there is a timer on the far right that should be for the headlamp washer delay/timer which you mightn't have.
As for the relays in the kick panels, Drivers side as far as I can tell they should be (left to right) sunroof, aux lamp, flasher/hazard,
and if you have relays in the passanger side that would mean you have less relays in the engine compartment as they appear to be nearly all the same (aircon/heater, compressor, aircon load, condenser fan, aircon diode)
I can scan the pages tomorrow if you like
Tom
according to my red haynes manual ... if you pop plastic cover off the engine bay relays then you should see 7 relays all lined up together.
from left to right these are
1. Aircon Fan relay
2. aircon relay
3. compressor clutch relay
4. Fan relay
5. Starter solinoid relay
6. Heater rear window relay
7. Brake failure warning check relay.
Now there is a timer on the far right that should be for the headlamp washer delay/timer which you mightn't have.
As for the relays in the kick panels, Drivers side as far as I can tell they should be (left to right) sunroof, aux lamp, flasher/hazard,
and if you have relays in the passanger side that would mean you have less relays in the engine compartment as they appear to be nearly all the same (aircon/heater, compressor, aircon load, condenser fan, aircon diode)
I can scan the pages tomorrow if you like
Tom
Who is online
Users browsing this forum: No registered users and 3 guests