I am trying to trace a water leak on my tb42. There are big plates bolted to the drivers side of the block just below the head. I am wondering what is behind these. Water galleries, oil channels or inspection areas etc for lifters???
Thanx
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Anyone know the insides of a TB42??
hahaaa, i can answer my own question. I found out that these plates are designed to allow an oil cooler to be fitted. Apparently these are fitted in middle east models, etc where temps are high. It is water channels behind these plates and the unit bolts over this area and the existing oil filter fitting, thus allowing water to draw heat from the oil. The oil filter then fits into this new body.
Who is online
Users browsing this forum: No registered users and 15 guests