How much are the TD42 glow plugs??
mine are rooted and not willin to use them on the new engine.
Any idea how much they are so i know whether its gunna burn a BIG or a small hole in my wallet :(
TOM
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
glow plug prices
Woop wrote:$42 each from Nissan for the original NGK's. Hows the re-build progressing Tom?
Nick
Progressing well, Just had the starter and alternator checked. Just gotta bolt them in this weekend.
And the major drawback in the build was i purchased a GU 4.2 turbo assembly which has considerably delayed everything as im gettin new oil/water lines made up and a few other things. Hopefully turnkey stage the following weekend
Sure im scared it'll go boom, but ive done everything properly and can only hope it goes well.
Hows yours going nick??
TOM
Mine back in and running--have done almost 1000kms now, but as Bruce said 
it does have a small oil leak at the back of the engine which i think is one of the small welshplugs in the oil galleries behind the flywheel. When i was assembling mine, the piston heights on mine were a fair bit higher above the deck than what the fact specify which worried me a bit--i had one which was 0.26mm when the book mentions it being normal at 0.15.... so i used another grade 3 gasket. Anyway engine started ok after a fair bit of cranking--engine wasnt too tight. I used crappy oil for the first 100km's then flushed out and re-filled with RimulaX 15W40. Brought a timming adaptor for the injection pump today so will check timing which i THINK may be not quite right....as its a bit difficult to start when cold.
I found performance hasnt really changed a huge amount compared to before--low end and mid range torque has improved largley but top end power no difference...
Nick
it does have a small oil leak at the back of the engine which i think is one of the small welshplugs in the oil galleries behind the flywheel. When i was assembling mine, the piston heights on mine were a fair bit higher above the deck than what the fact specify which worried me a bit--i had one which was 0.26mm when the book mentions it being normal at 0.15.... so i used another grade 3 gasket. Anyway engine started ok after a fair bit of cranking--engine wasnt too tight. I used crappy oil for the first 100km's then flushed out and re-filled with RimulaX 15W40. Brought a timming adaptor for the injection pump today so will check timing which i THINK may be not quite right....as its a bit difficult to start when cold.
I found performance hasnt really changed a huge amount compared to before--low end and mid range torque has improved largley but top end power no difference...
Nick
Who is online
Users browsing this forum: No registered users and 1 guest