Notice: We request that you don't just set up a new account at this time if you are a previous user. If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Trying to work out how the top of the centre dash section is secured so I can remove and install my UHF. I've found the obvious two screws either side at the bottom, and one screw behind the ashtray....but how is the top secured?
Trying to work out how the top of the centre dash section is secured so I can remove and install my UHF. I've found the obvious two screws either side at the bottom, and one screw behind the ashtray....but how is the top secured?
when i went to collect my gearbox rubber boot from the wreckers...
they needed to remove the centre dash console,,, took out the 2 screws in ash tray and on the side,,and got a pry bar to rip it out without takin the remaining 4 screws....
until i mentioned it to him (was watchin him while he took everything off)
when i went to collect my gearbox rubber boot from the wreckers...
they needed to remove the centre dash console,,, took out the 2 screws in ash tray and on the side,,and got a pry bar to rip it out without takin the remaining 4 screws....
until i mentioned it to him (was watchin him while he took everything off)
