I'm trying to find a 4wd friendly VicRoads approved engineer to certify 4wd modifications.
Having had an 'incident' rolling about on its roof waving its wheels about in the air (itchy back?) and declared a repairable write off, I've just reassembing the former 4Runner as follows:
- 1990 4Runner chassis, 3.0 litre petrol engine, 5 speed manual
- 1997 Dual Cab Body
The vehicle was previously engineered with the 4Runner body, by a NSW authorised engineering signatuory, for the following:
- 35 x 12.5 x 15 tires
- 50mm body lift
- coil converted front end (IFS removed, replaced by 80 series diff)
- A-frame rear-end
During the rebuild process, the rear diff, a-frame, trailing arms, tailshaft, handbrake cables (etc, etc) were lengthened 14 inches to accomodate longer body length. Rear coils are 2.5 inch over Landcruisers, fronts 4Runner + some inches.
The Lux's NSW rego expired during rebuild. Living now between VIC & NSW I hold VIC licence & regos (different vehicle). Pain in the a** as vehicle is in NSW, gotta trailer it back to VIC!
So I need to find a VicRoads certified engineering signatuory who can do the engineering of existing and new mods + RWC.
Any suggestions/contacts?
Bryce
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Wanted: 4WD Friendly VIC Engineer
Moderators: toaddog, TWISTY, V8Patrol, Moderators
Who is online
Users browsing this forum: No registered users and 0 guests