Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Valve clearances L28 MQ/mk

Tech Talk for Nissan owners.

Moderators: toaddog, V8Patrol

Forum rules
Post Reply
Posts: 3
Joined: Sat Nov 06, 2004 6:25 am
Location: devon uk

Valve clearances L28 MQ/mk

Post by jonny »

Your help again please ,Iknow the gaps to set these but any advice on how to set correctly would be a great help .....Also what order are the inlet and exhaust valves in ?I do not have a manual to give me the order(is it always the same in a straight six?)Thanks for your help ,Jonny
Top
User avatar
V8Patrol
God of Magnificant Ideas!
Posts: 6774
Joined: Mon Aug 04, 2003 11:22 am
Location: Balls Deep

Post by V8Patrol »

http://www.outerlimits4x4.com/PHP_Modul ... hp?t=22197

all the answers are there ...... or below !

Valve Clearance HOT
Intake - 0.25mm
exhaust - 0.30mm

Engine Oil Cap with filter change
-4.4L

Cooling system cap with heater
- 10.8L

Radiator Cap Relief Pressure
-88 KPA

Compression Pressure
standard - 1177 KPA
minimum - 883 KPA

Ignition Timing and idle speed
- 8 degrees at 650 RPM for manual trans
- At Idle Co % 2.0

Point Gap
-0.45 to 0.55mm

Dwell Angle
- 35 degrees to 41 degrees

Spark Plugs STANDARD
-BP6ES
-0.8 to 0.9mm

High Tension cables (leads)
-Resistance less than 30000 ohms

Kingy
[color=blue][size=150][b]And your cry-baby, whinyassed opinion would be.....? [/b][/size][/color]
Top
Post Reply

Return to “Nissan”

Who is online

Users browsing this forum: No registered users and 0 guests