Panhard bush

[stool]

Do i need a press to get the bush`s out of the panhard bar or can i just
use a vice and a bit of tube bigger than the bush and a bit smaller eg
same size as the bush and do it that way

[fatassgq]

Probably no reason you couldn't do it the way you state but could be a little fiddly and finding/having the right sizes of pipe for small and large could be difficult.

If you are replacing the bush then it may be easier to just cut the outer lips off each side and belt it out with a hammer and socket or similar.

This is what I did to get mine out recently. Putting em in is an easier job.

[bogged]

Can i just use a vice and a bit of tube bigger than the bush and a bit smaller eg same size as the bush and do it that way

thats how bazzle did mine...

[stool]

Thank`s Im going to buy new nissan bush`s how much should
thay cost from nissan

[bogged]

Thank`s Im going to buy new nissan bush`s how much should
thay cost from nissan

again search, the part #'s are actually given. You have to buy rear bushes if your doign front, Nissan will try and sell you the whole panhard... Front and rears are same!

[stool]

so what sort of coin am i looking at

[bogged]

so what sort of coin am i looking at

12 ea

[ozy1]

in sydney, i think i paid 17 each, i pressed em in using a vice, pushed the old nolethanes out using a but of oil and a screwdrived.

with the new bushes, smear em with grease, so the slide in nice,

[stool]

Thank`s Bogged
I was about to cut my arm off to pay for them. But thats well priced from
nissan so ile put the knife away for now

[bogged]

Panhard bushes
55135-01J01 top (small hole)
55135-01J10 bottom (large hole)
http://www.outerlimits4x4.com/PHP_Modul ... hp?t=22508
http://www.outerlimits4x4.com/PHP_Modul ... ard+bushes

[stool]

Just rang nissan and the kn@b on the phone kept telling me
their is no large hole and no small hole

but he can order the bush`s but thay are the same WTF

[ozy1]

if he orders those 2 part numbers, you should get what your after, no matter what he says,m then, when you get em, say, i told ya so.............dumbass

[bazzle]

About $18 each now. Bushes are same size but steel insert is different in middles.

Panhard bushes
55135-01J01 top (small hole)
55135-01J10 bottom (large hole)

DO NOT use GREASE when putting them in as it may make them go soft .

Use crc/wd40 etc and 2 sockets in vice.

Bazzle