Notice: We request that you don't just set up a new account at this time if you are a previous user. If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
ok this may have done before but cant find anything as the search thingo never works for me i cant get my bullbar off i want to take it off so i can be moded to suit 2 inch body lift but it will not come out its on an mg its one of the ones that slide into chassis ive wd40 it to death and belted it even tried a bottle jack oh by the way ive undone the bolts any other ideas would help plus has anyone done a lift on these bars and what was the best way cause the nuts are welded onto the bar were it slides in so the bolts dont go all the way through any help would be good any pics also great cheers
PUT YOUR HANDS UP IF YOU WANT TO GO FASTER
RTD Racing
OFFROAD CARTEL
bilby wrote:snatchstrap, big tree and reverse gear slowly if any thing mite loosen it up a bit
thought about this but was wondering if it would do more damage than good if it slipped from centre or something like an damaged chassis end or something i might be being to over cautious with it
PUT YOUR HANDS UP IF YOU WANT TO GO FASTER
RTD Racing
OFFROAD CARTEL
muduppig wrote:WOO HOO ITS OUT okay now thats done would anyone have pics on how theyve moded the bar to suit 2 inch body lift cheers
It'd be easy as drawing on a piece of paper...
Mounting holes... where they are positioned... they need to be 2 inches lower... so a plate in between is the logical answer.
In my case.. i'd make a whole new bracket duplicating the existing one but with the mounting holes in their new positions.
TOM
this would be ok if it was mounted like that this bar slides into the chassis rails with thw nuts welded to it and bolt though the chassis so its not that easy or i might be missing somthing
PUT YOUR HANDS UP IF YOU WANT TO GO FASTER
RTD Racing
OFFROAD CARTEL
havent got a digi but i think iam going to take it to an engineer shop etc because i want it lifted but also done properly so it doesnt drop off basicalywhat i was hoping is that some one had allready done it because its the same bar that you see on nearly every mq
PUT YOUR HANDS UP IF YOU WANT TO GO FASTER
RTD Racing
OFFROAD CARTEL
any other ideas would help plus has anyone done a lift on these bars and what was the best way cause the nuts are welded onto the bar were it slides in so the bolts dont go all the way through any help would be good any pics also great cheers 
if any thing mite loosen it up a bit
okay now thats done would anyone have pics on how theyve moded the bar to suit 2 inch body lift cheers
