hi
i have a sportrak 1993 what has code 11
car starts up ok but runs rich if you start it up and blip the throttle it cuts out untill it has warmed up it also runs a little rough
(Switch Signal (aircond switch, idle switch, throttle position sensor)
i dont have aircond so that leaves idle switch, throttle position sensor
how do i test them to see whitch one is working or not
thankx for any help
nice forum
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
help with code 11
Moderator: Tiny
The TPS is a variable resistor that is mounted on the throttle body.
Have you got a copy of the Service manual? That goes through the fault finding procedures in detail and how to check sensors out.
http://www.tunedloud.com/OuterLimits4x4 ... ervice.zip
Have you got a copy of the Service manual? That goes through the fault finding procedures in detail and how to check sensors out.
http://www.tunedloud.com/OuterLimits4x4 ... ervice.zip
David
thankx
one more thing i have been offerd an EFI inlet manifold off a P-reg Sportrak see pic does any one know if this will fit my 1993/4 efi sportrak
the manifold does not look the same as my one the throttle body is on the other side
thankx
nice forum
one more thing i have been offerd an EFI inlet manifold off a P-reg Sportrak see pic does any one know if this will fit my 1993/4 efi sportrak
the manifold does not look the same as my one the throttle body is on the other side
thankx
nice forum
You do not have the required permissions to view the files attached to this post.
Who is online
Users browsing this forum: No registered users and 1 guest