I have an 93 Mav. The previus owner had installed driving lights and the switch gear was located below the radio in the dash. There are a number of clip out oblong black plastic press in fittings where you can install switches and alike. One of the fittings has broken a tab which secures it into the opening. I want to replace it and all I would have to do is drill a hole in the fitting , mount the switch install the plastic fitting.
Are these a special Nissan fitting or industry standard. Can you get repo's or should a wrecking yard be the go. I pulled out the coin??? retainer thingy located in the bottom right hand corner of the dash and there are about 3 openings behind that where I could add further switches.
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Plastic togle switch dash board blanks
A speed camera would have prevented that!
Plastic togle switch dash board blanks
I am the Nightrider! I am the chosen one. The mighty hand of vengeance, sent down to strike the unroadworthy!
A speed camera would have prevented that!
Plastic plug
Thanks BlkMav.
RoadNazi
RoadNazi
I am the Nightrider! I am the chosen one. The mighty hand of vengeance, sent down to strike the unroadworthy!
Who is online
Users browsing this forum: No registered users and 2 guests