Hi,
Can anyone tell me where to find the place on the dash/intrument pod/fuse box where I can feed a tacho signal to drive the tacho in the instrument pod.
I have a Haynes manual but cant understand where the tacho wiring terminates, or where to find the wire in the engine bay which picked up the signal from the old TB42 (running 1UZ-FE now)
I have just found out that I can get a tacho signal from the 1UZ-FE from one of the igniters, the one with 5 wires (the fifth being a tacho output)
I am also hoping that the adjustment pot on the back of the tacho may enable me to calibrate the tacho for the V8 (4-cyl) signal (worth a try)
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
where to find the tacho input on a GQ dash...
the wire is near the resistor. i will look up its colour tomorrow. i am unsure if you can adjust to suit 6 - 8 cyl with a pot. you can buy a signal changer for $50 odd from jaycar and build it to suit that multiplication factor.
cheers bru
cheers bru
ADHD Racing would like to thank
Mrs Bru @ Sunshine Coast Developmental Physiotherapy - www.scdphysio.com.au , Ryano @ Fourbys www.generaltire.com.au Blitzkrieg Motorsport
Mrs Bru @ Sunshine Coast Developmental Physiotherapy - www.scdphysio.com.au , Ryano @ Fourbys www.generaltire.com.au Blitzkrieg Motorsport
Who is online
Users browsing this forum: No registered users and 2 guests