Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Cutting welds

General Tech Talk

Moderators: toaddog, TWISTY, V8Patrol, Moderators

Forum rules
Post Reply
Posts: 899
Joined: Mon Mar 28, 2005 7:52 pm
Location: BrisVegas

Cutting welds

Post by gu4800 »

Not being a welder (or any sort of handyman for that matter), thought I'd ask some advice here:-

Need to remove a gas bottle holder (the ring type) from the front chassis rail of my camper trailer (and also move the jockey wheel forward).

What is the best way to cut the welds without damaging the chassis rail? Want to cut it off clean, and not leave any part of the gas bottle holder there (ie, don't want to simply cut the gas bottle holder, but more the welds themselves)

If it is with an a grinder, what sort of cutting disk do I look for?

Thanks in advance.
____________________
Dan

[quote="v840"]I bet you're the kind of person, when you're railing someone in the ass
you don't even have the common courtesy to give them a reach around! [/quote]
Top
Posts: 1076
Joined: Tue Jul 27, 2004 8:49 am
Location: cashmere

Post by eliteforce32 »

from experience, and some one may correct me :armsup: , i use a wafer thin disc, on my 9 inch grinder to take welds off cleanly and use just a standard steel grinding disk to clean the rail :armsup:
Eliteforce Heavy Fabrication
Proud supporter of these businesses:-
Pig Dog Shop(hunting)- Greg 0448024776
CrispProducts(Racetec Gauges)-Chris(pm him)
Fourbies at Moorooka- Ryano
Top
Posts: 792
Joined: Mon Jan 05, 2004 4:43 pm
Location: Campbelltown, Sydney

Contact:
Contact Nev62

Post by Nev62 »

eliteforce32 wrote:from experience, and some one may correct me :armsup: , i use a wafer thin disc, on my 9 inch grinder to take welds off cleanly and use just a standard steel grinding disk to clean the rail :armsup:


Even a cheap 4 1/2" grinder would do.
FJ62 Crusier GM V8 Diesel Lockers 33 MTs/35 117 extremes
Macarthur District 4WD Club http://www.macarthur4wdclub.com.au
Top
Posts: 148
Joined: Tue Dec 03, 2002 9:03 am
Location: Blue Mountains, Sydney

Post by stephen »

a 1mm thick (.9 I think) metal cutting disk to cut it off just off the chassis and then a flap disk to carefully clean it up.
Top
Posts: 899
Joined: Mon Mar 28, 2005 7:52 pm
Location: BrisVegas

Post by gu4800 »

Thanks to all - mission accomplished.
____________________
Dan

[quote="v840"]I bet you're the kind of person, when you're railing someone in the ass
you don't even have the common courtesy to give them a reach around! [/quote]
Top
Post Reply

Return to “General Tech”

Who is online

Users browsing this forum: No registered users and 8 guests