Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

rebuilding warm m8000 low mount

General Tech Talk

Moderators: toaddog, TWISTY, V8Patrol, Moderators

Forum rules
Post Reply
Posts: 313
Joined: Wed Dec 11, 2002 12:20 pm
Location: Newcastle

rebuilding warm m8000 low mount

Post by Duff »

ive pulled apart the winch and i found that the ring gear for the clutch has sezised and wont free spool. how do i get it out as i put wd40 on it and it wont budge. has any one done one of these and can tell me what to do to rebuild it. as its my first time and its a very old winch
Top
Posts: 2820
Joined: Sun May 25, 2003 10:04 am
Location: Redbank Plains, QLD

Post by Daisy »

Gidday...

rebuild thread of the winch on pirate4x4...

http://www.pirate4x4.com/tech/billavista/8274/

Hope that helps...

TOM
Top
Posts: 2513
Joined: Sat Mar 05, 2005 1:14 am
Location: ingleburn

Post by familybus »

ive just finished pullin mine apart and cleaning it all up ready to put together! youl find that a lot of bits will be a pain but with WD and patiance itl all come good! once you strip it down youl see its a piece of piss!
Top
Post Reply

Return to “General Tech”

Who is online

Users browsing this forum: No registered users and 1 guest