hi,
I'm looking to do a toyota axel and diff centre conversion to an old landrover. For obvious reasons. I have some 30 spline 45 series ( i think ) inner axels to 6 spline outers. off a drum braked 45 (i think )
I will be upgrading them to 30 spline outers. I,ve already got the toy centres which can be made to fit the rover housings.
questions are:
1/ are the outer shafts (30 spline ) the same size (diam) as the inners? the 6 spline outers are smaller.
2/ are all 30 spline toyota axels (measured across the splines) the same diameter?
3/ is there a full floating 30 spline axel for the rear with the same track as a 45 series?
4/ are all the 30 spline outers the same length? (i need longer than the 6 spline units)
any help appreciated. thanks
sorry but its easier to ask here than to get off my arse and go to the wreckers with a tape measure.
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
30 spline axel width?
Moderators: toaddog, Elmo, DUDELUX
Who is online
Users browsing this forum: No registered users and 0 guests