just about to install a new manifold gasket and noticed that it has been bent at some stage. is this still ok to install???
I can see light through the two sides of the gasket.
and also, does it matter which side goes on the manifold ??
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
noob gasket question
Moderators: toaddog, TWISTY, V8Patrol, Moderators
noob gasket question
You do not have the required permissions to view the files attached to this post.
"Whenever you find that you are on the side of the majority, it is time to reform." (Mark Twain)
exhaust gasket???
exhaust gasket??? i always put some high temp silastic on both sides of exhaust gaskets just to make sure they seal. it doesn't look to bad just use it.
see ya mav
Who is online
Users browsing this forum: No registered users and 4 guests