have been thinking about building up an engine for my sierra just to be ready for when i kill this one.
Not sure but i think i read somewhere that the g13b and g16b are the same block with same bore size. is this true?
Will a 1.6 crank fit into a 1.3 block without changing the pistons or rods?
want to try to keep a 1.3 block and numbers so i dont need to get it fully engineered.
Thanx
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
engine questions
engine questions
1999 SQ625 Manual Grand Vitara. Lifted, Twin Locked, 31' Extremes, dual Batteries, Winch.
Lots of custom gear as I cant afford the proper stuff.
Lots of custom gear as I cant afford the proper stuff.
Re: engine questions
Built4thrashing wrote:
have been thinking about building up an engine for my sierra just to be ready for when i kill this one.
Not sure but i think i read somewhere that the g13b and g16b are the same block with same bore size. is this true?
There is a 1mm difference in the bore G13 @ 74mm and G16 @75mm
Will a 1.6 crank fit into a 1.3 block without changing the pistons or rods?
No hope.
want to try to keep a 1.3 block and numbers so i dont need to get it fully engineered.
Theory and practice are two totally different things on this occasion.
Thanx
have been thinking about building up an engine for my sierra just to be ready for when i kill this one.
Not sure but i think i read somewhere that the g13b and g16b are the same block with same bore size. is this true?
There is a 1mm difference in the bore G13 @ 74mm and G16 @75mm
Will a 1.6 crank fit into a 1.3 block without changing the pistons or rods?
No hope.
want to try to keep a 1.3 block and numbers so i dont need to get it fully engineered.
Theory and practice are two totally different things on this occasion.
Thanx
http://stores.shop.ebay.com.au/4wd-products
Who is online
Users browsing this forum: No registered users and 1 guest