Does anyone know how much a k&n filter costs for a 1.3?
Does anyone have any feedback from using them?
Cheers
Chop
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
K&N filter
K&N filter
I THINK ICAN, I THINK I CAN!
Check a thread calles "Don´t change your airfilter" or something close to that. Cut past all the bullshit posted on the thread and read about the test done on air filters. K&N were the worst of the lot when it came to filtering. They let through more air than standard filters maybe but to what cost?
AC Delco were superior to any other filters.
Ingthorsson.
ps: The bullshit is kinda funny though!
AC Delco were superior to any other filters.
Ingthorsson.
ps: The bullshit is kinda funny though!
if you don´t know its impossible, you just might do it!
K&N have always been reputable in my opinion, but have never used em. More air will perform better, but will probably filter less, hurting your engine long-term. Ideally, performance wise you'd be best off running without any filter whatsoever correct me if I'm wrong, to get the maximum amount of airflow.
nicbeer had fine sand getting through a K&N filter.
fine sand in the cylinder... mmmm..... abrasive....
He said that he knew of people that have and haven't had this problem.
Based on what he said I've just opted for stock at the moment.
fine sand in the cylinder... mmmm..... abrasive....
He said that he knew of people that have and haven't had this problem.
Based on what he said I've just opted for stock at the moment.
"It has the aerodynamics of a brick." - Comment about the Sierra by my dads mate.
Personally, I wouldnt value a pod style filter in a 4wd environment. In a street car without the mud and dust, it might be a different story.
For me, theres better ways to get more power than risking it on a bling filter. I'd put that 120 towards a 1.6 engine. Sure, your'e gunna need a few k&n's to make a 1.6, but thats what I'd do.
For me, theres better ways to get more power than risking it on a bling filter. I'd put that 120 towards a 1.6 engine. Sure, your'e gunna need a few k&n's to make a 1.6, but thats what I'd do.
ht zook with bog, rust and mt's
this is my wheelbase |<-------->|
this is my wheelbase |<-------->|
Its not a pod type, it goes in the air filter box.munga wrote:Personally, I wouldnt value a pod style filter in a 4wd environment. In a street car without the mud and dust, it might be a different story.
For me, theres better ways to get more power than risking it on a bling filter. I'd put that 120 towards a 1.6 engine. Sure, your'e gunna need a few k&n's to make a 1.6, but thats what I'd do.
Chop
I THINK ICAN, I THINK I CAN!
His point still does apply.
You would rarely encounter fine sand in a street car that always stays on the blacktop.
While if you often go on the beach or the dunes its going to be a real issue.
Plus the problem with getting a re-usable filter is that when you do have fine sand or whatever else getting in, the manufacturer can always say, you didn't install it properly, you didn't use enough/used too much oil, didn't clean it properly etc. Bottom line is it's not their fault
.
I personally decided it wouldn't really offer that great increase in performance or practicality for the risk.
You would rarely encounter fine sand in a street car that always stays on the blacktop.
While if you often go on the beach or the dunes its going to be a real issue.
Plus the problem with getting a re-usable filter is that when you do have fine sand or whatever else getting in, the manufacturer can always say, you didn't install it properly, you didn't use enough/used too much oil, didn't clean it properly etc. Bottom line is it's not their fault
.I personally decided it wouldn't really offer that great increase in performance or practicality for the risk.
"It has the aerodynamics of a brick." - Comment about the Sierra by my dads mate.
k&n
I put a K&N pod filter on my girlfriends zook. It cos $69 from Autobarn (they hav em on special now and then). Its the tapered one with a 3 inch pipe. Fits perfectly onto the stock box that goes on top of the carby. Its been on there for a year now, goes and sounds great. They also have a lifetime warranty. 
06 Grand Vitara Prestige, 2" lift, Kumho A/Ts, ARB winch bar, snorkel, spotties. Also a Regal 2150 LSC Volva Penta 350 gsi duoprop, and a kayak ;-)
Posts: 912
Joined: Tue Nov 09, 2004 6:29 pm
Joined: Tue Nov 09, 2004 6:29 pm
Location: {Sydney, Australia or Rio, Brazil Ride: Sierra JXi}
Jump on K&N's website.. plenty of data on it filtering minimum of 90-something percent (they point out this is not an average but the filtering capabilities of the worst filters due to OEM shape and that the same filters filtered much lower figures... i'm not going to look up specifics you know what to do etc)
I also read that independent website but i feel the guy set out to prove performance filters where useless where as K&N has to submit it's patented results to a goverment body
I've had my filter for 2000km's and had not had any trouble and engine did feel a bit more responsive and less gasping for air.. my rev's dropped from just under 900rpm to dead 800-ish at idle!
I am in no way sponsored by K&N or it's affiliates
I also read that independent website but i feel the guy set out to prove performance filters where useless where as K&N has to submit it's patented results to a goverment body
I've had my filter for 2000km's and had not had any trouble and engine did feel a bit more responsive and less gasping for air.. my rev's dropped from just under 900rpm to dead 800-ish at idle!
I am in no way sponsored by K&N or it's affiliates
-[b]Santos[/b][img]http://www.teamswift.net/images/smilies/icon_furious.gif[/img]
Suzuki, Jeep & Toyota Soft tops with welded seams for SALE (PM me)
Suzuki, Jeep & Toyota Soft tops with welded seams for SALE (PM me)
Posts: 912
Joined: Tue Nov 09, 2004 6:29 pm
Joined: Tue Nov 09, 2004 6:29 pm
Location: {Sydney, Australia or Rio, Brazil Ride: Sierra JXi}
Jump on K&N's website.. plenty of data on it filtering minimum of 90-something percent (they point out this is not an average but the filtering capabilities of the worst filters due to OEM shape and that the same filters filtered much lower figures... i'm not going to look up specifics you know what to do etc)
I also read that independent website but i feel the guy set out to prove performance filters where useless where as K&N has to submit it's patented results to a goverment body
I've had my filter for 2000km's and had not had any trouble and engine did feel a bit more responsive and less gasping for air.. my rev's dropped from just under 900rpm to dead 800-ish at idle!
I am in no way sponsored by K&N or it's affiliates
I also read that independent website but i feel the guy set out to prove performance filters where useless where as K&N has to submit it's patented results to a goverment body
I've had my filter for 2000km's and had not had any trouble and engine did feel a bit more responsive and less gasping for air.. my rev's dropped from just under 900rpm to dead 800-ish at idle!
I am in no way sponsored by K&N or it's affiliates
-[b]Santos[/b][img]http://www.teamswift.net/images/smilies/icon_furious.gif[/img]
Suzuki, Jeep & Toyota Soft tops with welded seams for SALE (PM me)
Suzuki, Jeep & Toyota Soft tops with welded seams for SALE (PM me)
Who is online
Users browsing this forum: No registered users and 0 guests