Notice: We request that you don't just set up a new account at this time if you are a previous user. If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
hey guys, after seeing some resonable looking winch's on ebay for a resonable price i wanna throught a 12V winch up the front of the bundy. my BB is a steel non whinch bar, what is envolded in turning it into a winch bar as such? can it be done or a bit of a no-go????
if theres room behind the bar to run a cradle attached to the chassis rails and its own plate with a fairlead attached to it.. so that the bullbar doesnt play a role in holding the winch??
i wasn't planning on fabbing my own bar as i don;t have a bender or welder.
how strong will the bracket have to be if the winch is going to be 9,000lbs? would it just be easier to do alot a supports on the bull bar in behind it???
if you dont have a bender or a welder, you prolly wont get far, prolly best to look at getting whinch bar or a fabricater or 4b shop to fit the winch into a cradle onto ur rig
What brand is your Bar???????????????
Pic??????????
A 8mm plate up either side may be all you require, with a brace along the front side to stop flex. Any flex will stuff the winch as it will make it bind.
