Guys,
Having some intermittent starting problems with the 60. Sometimes (seems to be only when warmed up) when I turn the ignition key to "on", the dash warning lights do not come on. The radio does, and if I hit "start", it will happily crank and fire for a few revs, then die. I've also found that sometimes the warning lights come on:
1) whilst cranking (then it will fire & continue to run)
2) if I turn the ignition key to off (then I can turn back to ON & start as though there was no problem)
I had a problem with the starter recently (just clicking instead of cranking) and this has been fixed (contacts corroded in the starter). (I've no idea how water could have gotten in there..... ....)
I had this problem (intermittently) prior to having the starter done, so I'm not going to assume that it was a result of the work (although I did find the auto-lecky left my oil-pressure sender disconnected and also left the end-cap bolts on the starter finger-tight).
A turbo-timer was on it when I bought it. While I have been somewhat suspicious that it could be a cause, it appears to be a solid-state device, so surely it will either work or not.
Ideas, anyone?
Oh, it's a 1988 60 with a 2H and after-market turbo.
Cheers.
P.S. I did search for related info, but couldn't find anything. Be gentle - I'm new here.....
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Intermittent warm starting problem - 60 series
Moderator: -Scott-
Depends what sort of turbo timer it is.There are 2 types.
1) You just join the wires of the Turbo timer to the wires on ignition switch.Hooking up in parallel.
If its this type i doubt that you will have a problem as the wires in the original loom are just that the original therefore will operate if it is removed.
2) The other type has 2 looms coming out of it.Firstly you pull out the original plug from the ignition switch,plug into one of the plugs on the timer, the othe loom goes to the ignition switch..
If it`s this type the best thing to do is,unplg the timer and put the original plug back onto the ignition switch.
I have seen type 2 play up abit.Try this and see how it goes.
Regards
Craig
1) You just join the wires of the Turbo timer to the wires on ignition switch.Hooking up in parallel.
If its this type i doubt that you will have a problem as the wires in the original loom are just that the original therefore will operate if it is removed.
2) The other type has 2 looms coming out of it.Firstly you pull out the original plug from the ignition switch,plug into one of the plugs on the timer, the othe loom goes to the ignition switch..
If it`s this type the best thing to do is,unplg the timer and put the original plug back onto the ignition switch.
I have seen type 2 play up abit.Try this and see how it goes.
Regards
Craig
Who is online
Users browsing this forum: No registered users and 0 guests