Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Stage 1 speedo cable

Tech Talk for Rover owners.

Moderator: Micka

Forum rules
Post Reply
Posts: 8459
Joined: Mon Nov 29, 2004 8:15 pm
Location: Townsville

Stage 1 speedo cable

Post by "CANADA" »

does anyone know if the speedo cable housing is the same as the series2 housings?


if not anyone know of a $ for new




canada
[quote="dazza30875"]whats "FAIL" mean[/quote]

[quote="fool_injected"]

Sometimes your funny Canada :D[/quote]
Top
Posts: 1403
Joined: Fri Jul 11, 2003 7:59 pm
Location: Melbourne

Post by DaveS3 »

Not sure if the bottom housing is the same as S2.
Same as series 3. They have the tapered square end.

Clip on end at the speedo.

About $30 new. Make sure its not the plastic gear or the gauge itself first.

Dave.
Land Rover Discovery - GQ conversion underway
Top
Posts: 8459
Joined: Mon Nov 29, 2004 8:15 pm
Location: Townsville

Post by "CANADA" »

no the housing is snaped right above where it loops down past the master cyl' and the cable is snaped there too...ill pull them both out today and check..would the routing be the same on the 4BD1 as the V8?
[quote="dazza30875"]whats "FAIL" mean[/quote]

[quote="fool_injected"]

Sometimes your funny Canada :D[/quote]
Top
Posts: 1403
Joined: Fri Jul 11, 2003 7:59 pm
Location: Melbourne

Post by DaveS3 »

Just do it however it fits.

Mine was a PITA to get into the firewall because of extra wiring...

Try to get it through the drivers side holes in the firewall, the most direct route with the least kinks/bends is the best way.

Dave.
Land Rover Discovery - GQ conversion underway
Top
Post Reply

Return to “Rover”

Who is online

Users browsing this forum: No registered users and 1 guest