Hi all
I installed a 2 inch body lift recently, but have just got around to extending the transfer case gear lever back to it's original position.
Is there a simple solution for this? I was trying to not have to weld inside the car...
Cheers
Andrew
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
transfer case gear lever extension
Moderator: Micka
10mm threaded socket from bolt place: (Hex bar with 10mm thread)
they are 50mm long and perfect for job.
Coventry Fastenrs ect.
Michael.
they are 50mm long and perfect for job.
Coventry Fastenrs ect.
Michael.
Mitsubishi 2010 NT DID Pajero wagon, Factory rear diff lock, Dual batteries, ARB bar, winch, Mt ATZ 4 rib tyres.
1986 RR.
Custom suspension links etc.
HSV 215 engine.
4.3 diffs.
1986 RR.
Custom suspension links etc.
HSV 215 engine.
4.3 diffs.
Who is online
Users browsing this forum: No registered users and 1 guest