Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

80 series bodylift

Tech Talk for Cruiser owners.

Moderators: toaddog, Elmo, DUDELUX

Forum rules
Post Reply
Posts: 1719
Joined: Sun Jan 25, 2004 11:45 am
Location: Brisbane

Contact:
Contact RV80

80 series bodylift

Post by RV80 »

Ok i've searched and can't find what i'm after.. What i would like to know is, what length bolts are required for a 50mm body lift? (don't say 50mm longer than the original ones :finger: ) I don't want to pull it apart and then go and buy bolts....
Thank's Grant
www.bolsys.com.au
Top
Posts: 398
Joined: Mon Jun 21, 2004 7:57 pm
Location: Berwick, Vic

Post by g35me »

8 x 155mm
2 x 210mm
Twin Turbo V8 80 Series Ute with Extra Bits
Top
Posts: 1719
Joined: Sun Jan 25, 2004 11:45 am
Location: Brisbane

Contact:
Contact RV80

Post by RV80 »

Thank's Brian.. Dumb question but the long ones are for the front? And i can only get 200mm long..
www.bolsys.com.au
Top
Posts: 398
Joined: Mon Jun 21, 2004 7:57 pm
Location: Berwick, Vic

Post by g35me »

the long ones are the front..5mm is the head thickness. Probably wont matter being 5mm short.
Twin Turbo V8 80 Series Ute with Extra Bits
Top
Posts: 1719
Joined: Sun Jan 25, 2004 11:45 am
Location: Brisbane

Contact:
Contact RV80

Post by RV80 »

Well what a prick of a job :bad-words: two bolts where rusted in :bad-words: so i cut the front bolt in half and got it out, then the one at the back door was rusted in, so i flogged the crap out of it with FBH :D .. So i'm half way through it now :D , but i'm on call so i have to go and unblock someones shit pipe :x then back into it.. Will put some pic's up when i'm done..
Grant
www.bolsys.com.au
Top
Posts: 1719
Joined: Sun Jan 25, 2004 11:45 am
Location: Brisbane

Contact:
Contact RV80

Post by RV80 »

Here's a pic of some 50mm RHS i used as support for under the back where there was a bracket to the chassis and a rubber attached to the body... I just got the local exhaust shop to zap it on :D
You do not have the required permissions to view the files attached to this post.
www.bolsys.com.au
Top
Post Reply

Return to “Cruiser / Prado”

Who is online

Users browsing this forum: No registered users and 1 guest