Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
3.5 SWB Misti Locker ECU HELP
Moderator: -Scott-
3.5 SWB Misti Locker ECU HELP
I have found a rear locker for a 3.5 Pajero which im planing on transplanting into my pajero.
The guy who is dismantling for me it cant find the locker ECU he has had a look for a faulse floor under the rear seats. Can someone please tell me where is this where it is supose to be located? It is being removed from a SWB NJ
Can you run it without the ECU?
The guy who is dismantling for me it cant find the locker ECU he has had a look for a faulse floor under the rear seats. Can someone please tell me where is this where it is supose to be located? It is being removed from a SWB NJ
Can you run it without the ECU?
Last edited by doddzee on Thu Sep 29, 2005 6:07 am, edited 2 times in total.
From this thread: http://www.outerlimits4x4.com/PHP_Modul ... hp?t=26709
this is what the ECU does:
Cheers,
Scott
this is what the ECU does:
Go without!M1S3RY wrote:Just looked at the manual and it the diff lock will only work in 4LO. If the diff lock is in and you change into 4HI or 2HI it will automatically unlock.. (Super Select 4WD)
Cheers,
Scott
Yes you can run it without the ECU but you will need the compressor.
All you really need is a dash switch (use something like an ARB locker switch not the factory one) and power to activate the compressor when the switch is turned on.
This will allow locker engagement at any time the factory ECU only allows engagement in low range and below 12km/hr.
The only thing you won't have with the above set up is the orange dash difflock light coming on when the locker is engaged. This is meant to tell you that the locker has physically engaged via a sensor in the diff. You can still wire it through a diode to the dash light to do the same thing.
Ian Sharpe did this also try looking in the tech archive section there's heaps of imfo there.
All you need is the diff centre and axles (with brakes) they will bolt into a lsd housing and the compressor. Use an aftermarket switch and some creative wiring and all will be sweet.
All you really need is a dash switch (use something like an ARB locker switch not the factory one) and power to activate the compressor when the switch is turned on.
This will allow locker engagement at any time the factory ECU only allows engagement in low range and below 12km/hr.
The only thing you won't have with the above set up is the orange dash difflock light coming on when the locker is engaged. This is meant to tell you that the locker has physically engaged via a sensor in the diff. You can still wire it through a diode to the dash light to do the same thing.
Ian Sharpe did this also try looking in the tech archive section there's heaps of imfo there.
All you need is the diff centre and axles (with brakes) they will bolt into a lsd housing and the compressor. Use an aftermarket switch and some creative wiring and all will be sweet.
I just luv my "clacker Jabber"
The location of the ecu is inside of the plastic panel cover of the passenger side of the rear part of the interior.
If you take the ash tray out (left rear passenger) and remove the screw that holds the ash tray surround in place you can see the little box with wires coming out of the bottom of it. Its position is a little up and a little to the rear of the ash tray hole.
This will help you to locate it.
But if want to remove it you will have to take the rear seat out and remove the bottom plastic panels .
Its time consuming but not hard to do.
If you need any more help just hollar.
Cheers
If you take the ash tray out (left rear passenger) and remove the screw that holds the ash tray surround in place you can see the little box with wires coming out of the bottom of it. Its position is a little up and a little to the rear of the ash tray hole.
This will help you to locate it.
But if want to remove it you will have to take the rear seat out and remove the bottom plastic panels .
Its time consuming but not hard to do.
If you need any more help just hollar.
Cheers
We get the 3.0 Swb's here aswell a mate of mine just bought a 1996 3.0 Swb.
Mines a 1995 3.5 Swb
Not sure if you do in aussie but i we have a few 3.5 Swb soft tops around aswell
Anyone had experence with 35's on a 3.5? i am about to fit some mudzillas to mine anyone run into any problems?
Clearance was obviousley the first problem but i have fixed that
Mines a 1995 3.5 Swb
Not sure if you do in aussie but i we have a few 3.5 Swb soft tops around aswell
Anyone had experence with 35's on a 3.5? i am about to fit some mudzillas to mine anyone run into any problems?
Clearance was obviousley the first problem but i have fixed that
you will strugle with 35's. a few things to consider are gearing - paj low range is rather dismal and will strugle turning 35's. Also it will put greater stress on your front end you'll most likely start distroying stuff, bend idler arms, break tie rods, bend steering arms and smash cv's and stuff.
I was going to run 35's on mine but after a bit of research decided best to stay on 33's.
check this out
http://www.outerlimits4x4.com/PHP_Modul ... hp?t=52398
cheers
I was going to run 35's on mine but after a bit of research decided best to stay on 33's.
check this out
http://www.outerlimits4x4.com/PHP_Modul ... hp?t=52398
cheers
He who laughs last thinks slowest.
Re: re
Yes, definately available in AUS. My old 95 NJ wagon was a 3.5 DOHC manual, with the triple diamond pack including ABS, Adj Shocks and Factory rear difflock. Had the big ass sun roof too, was a great vehicle but they are very rare in that config.Grantw wrote:Last time I checked, Nj SWB only came in 3.0L not 3.5L..... Correct me if im wrong here.
3.5L diffs are not the same as 3.0L.
KRiS
Who is online
Users browsing this forum: No registered users and 0 guests