Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Mounting antennas

General Tech Talk

Moderators: toaddog, TWISTY, V8Patrol, Moderators

Forum rules
Post Reply
Posts: 176
Joined: Wed Jun 09, 2004 8:43 pm
Location: South Brisbane

Mounting antennas

Post by shortgq »

After finally mounting the bull bar i've had sitting around for ages... i can also install the antennas for both my am and uhf two ways. Just wondering whether there is a minimum distance i should keep between the antennas to ensure their best performance????


ANy other tips would be good too... especially for the uhf as i've never mounted uhf antenna before

Cheers
Top
Posts: 2097
Joined: Mon Jun 14, 2004 8:06 pm
Location: Land of Plenty

Post by blkmav »

I wouldn't bother with the AM
Weekdays - Prado GXL D4D with some stuff
Weekends - Mav shorty with lots of stuff
Top
Posts: 2001
Joined: Wed May 26, 2004 9:47 pm
Location: sydney

Contact:
Contact runnin4life

Post by runnin4life »

my old man has mounted his antena's on the base of the bull bar on each side
if that makes sence
Top
Posts: 253
Joined: Tue Sep 13, 2005 12:55 pm
Location: Sydney, Australia

Post by Firegod »

Usually need to be a 1/4 length away from each other at least to avoid interference etc...

So, which ever is the longest divided by 4.

If the longest antenna measures a meter, then the antenna bases need to be at least 25cm apart.

Also avoid running the coax cable together, as in taped or cable tied together. Also avoid running them near vehicle computers and any major vehicle cable loom or main engine fuse block.

I had a suped up radio that would make the head lights glow when I transmitted because the coax ran near the lighting loom.

Also be careful with RF burn, in other words don't touch the antenna or base when transmitting. Can be nasty!


:twisted:
I love going around to the school and watchin the kids run and scream. They don't know i am using blanks! -FG
Top
Posts: 45681
Joined: Wed Nov 27, 2002 10:13 am

Re: Mounting antennas

Post by bogged »

shortgq wrote:After finally mounting the bull bar i've had sitting around for ages... i can also install the antennas for both my am and uhf two ways. Just wondering whether there is a minimum distance i should keep between the antennas to ensure their best performance????
Cheers
Telstat sorted out issues I had with mine, they were too close together. Now 1 each side of the bullbar.

But as said, dont waste your time with 27meg, it just aint worth it.
Top
Posts: 5179
Joined: Fri Dec 05, 2003 8:15 pm
Location: Brisbane Australia

Post by Shadow »

if youve gotta have both definantly put them either side of the bullbar.

The further apart they are the less they will intefere with eachother. Ideally you would have thgem about 25metres apart.
Top
Posts: 2492
Joined: Sun Nov 24, 2002 8:57 pm
Location: Melbourne

Post by bazzle »

I have tried to have them as far apart as I could.
In reality when I moved them to about 200mm apart I have found no broblems.
One each side of unright.

Bazzle
Top
Post Reply

Return to “General Tech”

Who is online

Users browsing this forum: No registered users and 3 guests