Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

80 series power upgrade

Tech Talk for Cruiser owners.

Moderators: toaddog, Elmo, DUDELUX

Post Reply
Posts: 7
Joined: Thu Sep 08, 2005 7:59 am
Location: ACT

80 series power upgrade

Post by 88 Shorty »

Hello,
I've heard you can make petrol 80s quicker by advancing the timing, how much does this need to be done by please, also what size exhuast etc is best.


Thanks
Posts: 2097
Joined: Tue Aug 12, 2003 6:50 pm
Location: wollongong

Post by dow50r »

You can, but are you willing to run premium unleaded??? If so, advance it to 6 degrees from 3 and put premium in...if u use normal fuel, you will go backwards in power. Cut the 2 into 1 piece off the engine pipe and put something descent ion there, and dont touch the system unless yu want it to be loud. If u dont mind, loose the round muffler for a nice free flow one...the other two mufflers are straight through.
Andrew
Posts: 7
Joined: Thu Sep 08, 2005 7:59 am
Location: ACT

Post by 88 Shorty »

Thanks andrew
Posts: 766
Joined: Sun Aug 01, 2004 7:16 pm
Location: brisbane

Post by bruiser »

Also, if you do this mod and the motor pings / nocks from using standard unleaded a sensor detects this and automatically retards you timing back to the way it was or possibly worse.
Correct me anyone, if I'm wrong as I cant remember where I got this info from.
Steve
Posts: 1719
Joined: Sun Jan 25, 2004 11:45 am
Location: Brisbane

Post by RV80 »

bruiser wrote:and automatically retards you timing back to the way it was or possibly worse.
dow50r wrote:if u use normal fuel, you will go backwards in power.
:D
www.bolsys.com.au
Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests