got to do the tappets in my L28 tonight.. dont know what they are or what to do... does it eaven have them? but yeh, got a my mechanics coming around (friends who are apprentice mechanics) and they will do them... so what do the need to be set on? (do they have to be set on something?) ect....
any specs or stuff for them?
sorry... but i have no idea, and need help.
thanks
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
tappets... L28
They do have tappets...
they are set using a feeler guage, im not sure what the guage setting is, but its the same for all of them.....
basically just set them and it gets rid of the ticking noise coming from your motor.....
they are set using a feeler guage, im not sure what the guage setting is, but its the same for all of them.....
basically just set them and it gets rid of the ticking noise coming from your motor.....
TUFF TRUCK TEAM OPPOSITE LOCK Proudly Sponsored By:
Opposite Lock Narellan, Lightforce Australia, Offroad Systems, Judd Panels, Townsend Signs, RDG Engineering, Central Safety Workwear
Opposite Lock Narellan, Lightforce Australia, Offroad Systems, Judd Panels, Townsend Signs, RDG Engineering, Central Safety Workwear
God of Magnificant Ideas!
What ya looking for ........
Valve Clearance HOT
Intake - 0.25mm
exhaust - 0.30mm
and while ya are at it, check these too .....
Ignition Timing and idle speed
- 8 degrees at 650 RPM for manual trans
- At Idle Co % 2.0
Point Gap
-0.45 to 0.55mm
Dwell Angle
- 35 degrees to 41 degrees
Kingy
Valve Clearance HOT
Intake - 0.25mm
exhaust - 0.30mm
and while ya are at it, check these too .....
Ignition Timing and idle speed
- 8 degrees at 650 RPM for manual trans
- At Idle Co % 2.0
Point Gap
-0.45 to 0.55mm
Dwell Angle
- 35 degrees to 41 degrees
Kingy
[color=blue][size=150][b]And your cry-baby, whinyassed opinion would be.....? [/b][/size][/color]
God of Magnificant Ideas!
I didnt know what the hell a "tappet" was up untill about 15 years ago either !!!!!
always known it as valve clearance, valves, lifters ( hydrolic / solid ), push rods, rockers, roller rockers.......
you name it ............. but "tappets" .... WTF
guess its just a case of who taught ya !
Kingy
always known it as valve clearance, valves, lifters ( hydrolic / solid ), push rods, rockers, roller rockers.......
you name it ............. but "tappets" .... WTF
guess its just a case of who taught ya !
Kingy
[color=blue][size=150][b]And your cry-baby, whinyassed opinion would be.....? [/b][/size][/color]
Who is online
Users browsing this forum: No registered users and 4 guests