hey guys my fuel pump is possibly on its way out cause it whines so much unda acceleration. im gettin quotes of bout $251+ for geniune. is that 2 much? can anyone get a cheaper quote than this for me, but stil remainin easy to install. also wat bout using a second hand unit? other than the feroza, is there anyone that has used a pump off another vehicle to fit in place of the original?
also went to pedders today for suspension chec, an they told me my front torsion bars are rooted from previously bein wound up too high. they quoted me $450 for the lot. is that a good price or is there cheaper? also the rear shackles are warped-read orginals an never replaced- they quoted $300+. am i being ripped off here? any help would be good guys.
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
feroza fuel pump prob + suspension prob too
Moderator: Tiny
my fuel pumps whines all the time. I can actually feel it vibrating sometimes. Still works though so i havent been bothered looking into it.
I actually wanted to check someone elses fez to compare (your close to me, Leichhardt..)
torsion bars.. seems about the right price, i wouldnt get them from pedders though.
Rear shackles.. I'll sell you mine original ones for $150 HAHAHA if it bothers you then get a set made up at a metal shop approx $50-100.
I actually wanted to check someone elses fez to compare (your close to me, Leichhardt..)
torsion bars.. seems about the right price, i wouldnt get them from pedders though.
Rear shackles.. I'll sell you mine original ones for $150 HAHAHA if it bothers you then get a set made up at a metal shop approx $50-100.
Be very careful of Pedder's diagnostic skills on suspension problems. I'm sure there are some good stores out there, but I've heard plenty of negatives (eg. near new components being diagnosed as stuffed.)
The diving under brakes could be caused by your tyres being underinflated or the rear end springs/ shocks being on their last legs too. I know the dive on mine was virtually eliminated when I had rock hard rear springs!
The diving under brakes could be caused by your tyres being underinflated or the rear end springs/ shocks being on their last legs too. I know the dive on mine was virtually eliminated when I had rock hard rear springs!
David
I second that!murcod wrote:Be very careful of Pedder's diagnostic skills on suspension problems. I'm sure there are some good stores out there, but I've heard plenty of negatives (eg. near new components being diagnosed as stuffed.)
!
They may be ok with sedans and the like, but their knowledge of 4wd suspensions is questionable.
I had them replace the radius arm bushes on my GQ (I supplied the parts coz genuine item) and they managed to butcher fit three and totally destroyed the fourth! Then they blamed the part (which was OE ni$$an) for being wrong!
Dont expect mere proof to sway my opinion.
My fuel pump doesn't make much noise at all. There's a fuel flow test and pressure test you can do in the Service manual - could be worth checking before handing over $$$ for a pump.
VL Commodores had a similar external pump. You will probably find the mixtures would be affected due to the differing pump rates though? You would probably need to fit an adjustable fuel pressure regulator and get somebody to check the mixtures and set it up?
VL Commodores had a similar external pump. You will probably find the mixtures would be affected due to the differing pump rates though? You would probably need to fit an adjustable fuel pressure regulator and get somebody to check the mixtures and set it up?
David
Who is online
Users browsing this forum: No registered users and 45 guests