Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Mitsubishi Pajeros

Tech Talk for Mitsubishi owners.

Moderator: -Scott-

Post Reply
Posts: 216
Joined: Mon Oct 20, 2003 9:19 am

Mitsubishi Pajeros

Post by newbyferoza »

Hey I have been looking at mitsubishi pajeros nh nj and have just got a few questions for you. I know they are ifs and I have a feroza so am used to it, but just want to know about modifying it as am going to keep it for about five years.

Just wondering if you can get front and rear airlockers, snorkels, gearing etc etc

Also what suspensions mods mods are best and for what prices can you get for them

Was hoping to get 33" muddies on there, what mods would I have to do to do that

Also are there many mitsubishi drivers on here from Brisbane and are there any mitsubishi 4x4 clubs in Brisbane
have hundreds of mods planned by the year 2020
Posts: 315
Joined: Thu Jul 29, 2004 6:53 am
Location: South Australia

Post by cookie monster »

if you get a 3ltr manual, you can get all the goodies. f & r lockers(i think the front arb locker will fit), low range gearing, snorkals etc. front suspension can be cranked 40-50mm easily enough, rear is coils, so no probs. you can then run 33's no probs.

if you get a 3.5ltr, you can only get a factory rear locker, but arb do a front locker. low range gearing is on the way(contact our resident mitsi guru Bitsammisin).
33's will fit with no suspension mods apparantly.

cookie monster
99 GU Patrol Wagon 4.2td
Posts: 421
Joined: Thu Apr 15, 2004 11:47 pm
Location: Brisbane

Post by grumpy221 »

good choice a couple of things though u can get nh 3lt with factory rear locker if u look about a bit but u will need to crank up the front suspension and go some bigger spings on the rear to put 33's on with the right rim offset. nj with 3.5lt will take 33's stock???? or with just a bit of up in the front??? I have a nh 3lt and run 32's next will be 33's ........ when looking for 1 watch out for smoke when u start it these things do have a problem with valve guide seals but once theyre runnig no smoke and yes there is the mitsi 4x club http://www.mitsu4wdclubqld.org/ I havent joined but have spoken to a few of them. were u down at ormeau on sunday?
91 Pajero GLS
32 BFG'S
and a lot of scratches
I Hate Lantana!!!!!
Posts: 90
Joined: Tue Aug 16, 2005 2:53 pm
Location: Wellington NZ

Post by doddzee »

yip i have had 33's on a 3.5 with no lift. Now i have done a ball joint flip and gone up 2.5 inches i have run 35 inch claws with no rubbing. Only problem was the gearing bit scary down hill!
Posts: 1908
Joined: Thu Aug 04, 2005 8:09 pm
Location: central queensland

cost

Post by known 2 »

how much lift can u get out of its suspension befor ur have to do major mods to the front end
and how thirsty is the v6
kaylee 2004 hdj78 RV. 33 mickey atz's, winchbar, 3i lift, 3i exhoust, spoties, roofracks and ufh. pimped interior .

86 lwb zook wt soa, 33's, locked, bard up, prety lights. monster tacho:/
Posts: 90
Joined: Tue Aug 16, 2005 2:53 pm
Location: Wellington NZ

Post by doddzee »

i get 16l/100km

I managed to get 75mm out of the front with the ball joint flip. No problems with it so far.

I also put manual hubs on it to save the cv's and boots
Posts: 33
Joined: Tue May 31, 2005 6:28 pm
Location: Athens,Greece

Post by vpaj »

What is the ball join flip?????
www.nomad.gr
2000 NM 3.5 V6
+2" ToughDog
Come up 9000
Custom steps and rear bumper
Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests