Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

my rear axle

Tech Talk for Nissan owners.

Moderators: toaddog, V8Patrol

Forum rules
Post Reply
Posts: 1187
Joined: Sat Nov 01, 2003 5:05 pm
Location: melbourne, Knoxfield

Contact:
Contact matthewK

my rear axle

Post by matthewK »

question ? where in melbourne can i get my axle oil seals done for a low $$ iv already done inner seals on both sides, but need to replace the outer oil seal behind the bearing? and i need the bearing pressed on and off any help will be good


matthew
1995 land rover disco on 265 muddies
Top
Posts: 1084
Joined: Sun Apr 04, 2004 9:33 pm
Location: Aotearoa

Post by J Top »

the outer seal is only a grease in and dirt out seal, there shouldn't be any oil in there. How much play is there in your wheel brgs.
J Top
Top
Posts: 1187
Joined: Sat Nov 01, 2003 5:05 pm
Location: melbourne, Knoxfield

Contact:
Contact matthewK

Post by matthewK »

honestly i cant notice anything, i replaced the inner seals but i still got oil all over my raer disc pads, thought it could of been outer seal
1995 land rover disco on 265 muddies
Top
Posts: 108
Joined: Thu Dec 15, 2005 9:56 pm

Post by Mkdude »

i just done wheel bearings and seals in mine, piece of piss, i'd do the lot at once for piece of mind, bearing kits were $30 each, and took about 15minutes a side
Top
Posts: 485
Joined: Wed May 05, 2004 8:04 am
Location: parramatta

Post by viperguy »

will be ur inner seal matey. very easy to damage when putting axle back into diff housing. for oil to be on ur pads it has to get past ur inners first so these must be the culprit. check ur axles as they may be slightly worn and need a speedy sleeve. also check ur breather hose for obstruction, forcing oil past ur seals.
Top
Posts: 1187
Joined: Sat Nov 01, 2003 5:05 pm
Location: melbourne, Knoxfield

Contact:
Contact matthewK

Post by matthewK »

breathers fine first thing i checked

mk dude how much all together for both side and the bearing to be pressed on and off?


as for a speedy sleave please explain????
how much and where from?

thanks guys
1995 land rover disco on 265 muddies
Top
Posts: 625
Joined: Fri Feb 20, 2004 12:04 am
Location: Melbourne

Post by Woop »

Mkdude wrote:i just done wheel bearings and seals in mine, piece of piss, i'd do the lot at once for piece of mind, bearing kits were $30 each, and took about 15minutes a side
Where were they $30 :shock: Are you sure that was for a GQ?

Nick
Top
Posts: 17
Joined: Wed Aug 13, 2003 3:24 pm
Location: Brisbane

Contact:
Contact amazoniandad

speedy sleve

Post by amazoniandad »

The speedy sleve is a press on hollow sleeve that brings the old axle back to the original or slightly bigger diamitor. If there is a groove worn in the axle from the seal, the sleeve gives the seal a new serface to run on and seal teh oil in the diff. Hope this helps
Regards
Stephen
Top
Posts: 1187
Joined: Sat Nov 01, 2003 5:05 pm
Location: melbourne, Knoxfield

Contact:
Contact matthewK

Post by matthewK »

next really stupid question where can i get them ? how much?

matt
1995 land rover disco on 265 muddies
Top
Post Reply

Return to “Nissan”

Who is online

Users browsing this forum: No registered users and 6 guests