Is there any way to strengthen these? i've already done one idler shaft, AND yesterday my second case blew the rear off it trying to drive slowly up a ledge. i had good traction, and was at a bout 2000rpm in low first when it went "pop" and then i had no drive.
anyone got a fix for em?
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
early (pre 79) cruiser transfer cases
Moderators: toaddog, Elmo, DUDELUX
early (pre 79) cruiser transfer cases
Spit my last breath
i think he means use the 60 series gearbox too,Zeyphly wrote:How worn out were the transferes when they failed? Was the new one reco'd or just second hand? I thought 60's had a different output spline off the grear box?
my first one was worn, the second one was an awesome condition low k second hand one.
the first one did an idler shaft but the case stayed in tact, will the T case bracket help that by takin the load off the idler shaft.
the second one i believe did an idler shaft, but it was impossible to reconstruct the bits to see a point of failure
Spit my last breath
Drill the idler shaft (8mm) through the centre.
Make a large (20-25mm) heavy flat washer for each end.
(you'll need to set in an 'o' ring on the gearbox end washer).
The gearbox end washer has a threaded hole, the rear one an 8mm hole.
Bolt together with a very long capscrew from the rear threaded into the gearbox side washer.
Spreads the load on the idler gears to both sides of the casing instead of just the rear.
If you want to get really keen - you could turn out the idler gear to take taper roller bearings instead of the needles.
Make a large (20-25mm) heavy flat washer for each end.
(you'll need to set in an 'o' ring on the gearbox end washer).
The gearbox end washer has a threaded hole, the rear one an 8mm hole.
Bolt together with a very long capscrew from the rear threaded into the gearbox side washer.
Spreads the load on the idler gears to both sides of the casing instead of just the rear.
If you want to get really keen - you could turn out the idler gear to take taper roller bearings instead of the needles.
hmmm this and the brace might be an idea. thanks guysandrewfarmer wrote:Drill the idler shaft (8mm) through the centre.
Make a large (20-25mm) heavy flat washer for each end.
(you'll need to set in an 'o' ring on the gearbox end washer).
The gearbox end washer has a threaded hole, the rear one an 8mm hole.
Bolt together with a very long capscrew from the rear threaded into the gearbox side washer.
Spreads the load on the idler gears to both sides of the casing instead of just the rear.
If you want to get really keen - you could turn out the idler gear to take taper roller bearings instead of the needles.
Spit my last breath
Who is online
Users browsing this forum: No registered users and 142 guests