1996 110 300Tdi LHD
Fuse #3 (15amp) keeps blowing as soon as ignition is on. Electrical diagram for 1997 year shows this fuse controls the line labelled "C" (on the left side, green wire) of the pic below which goes to connector 285.
Anyone know where this connector is located? Plan is to disconnect wires from this connector until short is discovered.
Looks like 96 is same as 97 year since the nonfunctioning things are: directionals, rear wiper/washer, temp/fuel gauges
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
fuse #3 blown: no directionals, gauges, rear wiper
Moderator: Micka
fuse #3 blown: no directionals, gauges, rear wiper
You do not have the required permissions to view the files attached to this post.
-Art
97 D90 SW, 96 110 300Tdi, 93 LWB
97 D90 SW, 96 110 300Tdi, 93 LWB
Who is online
Users browsing this forum: No registered users and 2 guests