Lads,
Have any of you poor buggers replaced your valve stem seats in your 3.5l DOHC 24V?
I wanna have a go using an air fitting so I don't have to pull the heads off - because mine smokes more at idle than 'cruiser CVs on a reverse hill climb!
any experiences, warnings, laughter??
Ado
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
DIY Valve stem seals for 3.5l Quadcam?
Moderator: -Scott-
DIY Valve stem seals for 3.5l Quadcam?
JK Unlimited Rubicon
2" lift
Dual locked, 1:4 crawler gears, swaybar disconnect
Stock and loving it
Mods to come
2" lift
Dual locked, 1:4 crawler gears, swaybar disconnect
Stock and loving it
Mods to come
Ours will hopefully be getting these done shortly... Ooo its a big money pit at the moment... My girls old man is a mechanic so maybe I can get some photos of the process and a little write up... I want them done as it puffs are a few minutes at idle (better get it sorted sooner than later I say), but it depends on what he says, grrrr 
Who is online
Users browsing this forum: No registered users and 0 guests