Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Mixing JetA1 & Diesel
Moderators: toaddog, TWISTY, V8Patrol, Moderators
Mixing JetA1 & Diesel
I have been pondering this for a while - ever since I found out how much JetA1 fuel we throw out at work. Can JetA1 which is basically refined Kero be mixed with diesel to give better performance or better economy. Just a thought?
Last edited by BOB_1 on Fri Feb 03, 2006 8:23 am, edited 1 time in total.
i used to have a hand sprayer of petrol to start the tractor in the morning when it was below 0. remove the air cleaner, prime the pump, hit the glow plug, wait for it to 'pop' then crank it over while spraying petrol into the air intake....started every time.....
Greg
Greg
Greg
2008 Jeep Wrangler Unlimited, Renegade pack, 2" RE Lift, JKS Quicker Disconnects, Seat Glover seat covers.
2008 Jeep Wrangler Unlimited, Renegade pack, 2" RE Lift, JKS Quicker Disconnects, Seat Glover seat covers.
I don't know but this study came up with a figure of 30% kero with diesel as reducing emissions.
http://www.ieindia.org/publish/mc/0404/apr04mc1.pdf
I suppose it would also be like mixing your own winter diesel. If it was me then I would like to know more before putting my engine at risk.
http://www.ieindia.org/publish/mc/0404/apr04mc1.pdf
I suppose it would also be like mixing your own winter diesel. If it was me then I would like to know more before putting my engine at risk.
[quote="4WD Stuff"]
I haven't quoted Grimbo because nobody takes him seriously :finger: :finger: :finger: :finger: [/quote]
I haven't quoted Grimbo because nobody takes him seriously :finger: :finger: :finger: :finger: [/quote]
It is a drier fuel and it also burns alot hotter, its not a got idea because it will stuff your engine, I work in the aerial ag industry and the pilots use JETA1 in the work utes, one only lasted about 20 000 KM
Duct tape is like the force it has a Dark side a Light side and holds everything together
i doubt it would be good long term. all the seals in the pump would be suited to diesel, not Jet A1? Maybe not enough lubricant in the jet a1. Even if you had to do a pump rebuild every year (~$900), you might work out ahead given the current price of diesel.
given the cost of rebuilding diesel, i would thoroughly check it out with people that really know what they are talking about.
given the cost of rebuilding diesel, i would thoroughly check it out with people that really know what they are talking about.
jet a1
Have seen blokes use 50/50 AVTUR (basically jet A1 with FSII and milspec lube added) and diesel. Used for the same reason your thinking of it, a lot gets thrown out.
I cant recall anyone stateing this did any damage, thtas not to say it didnt happen.
Would be interesting to see what the exhaust temps were on straight diesel and then with a progressively greater amount of jet A1 added.
Any takers?
I cant recall anyone stateing this did any damage, thtas not to say it didnt happen.
Would be interesting to see what the exhaust temps were on straight diesel and then with a progressively greater amount of jet A1 added.
Any takers?
Reliability lies in the state of your wallet.........
Enjoy your family,friends and kids,remember no one gets out alive.
Enjoy your family,friends and kids,remember no one gets out alive.
I work with millitary aircraft and I used to run Jet A1 with "fuel system icing inhibitor"(FSII) added. This acts as both a lubricant and it kills bacterior that grows in the layer between fuel and water. For jet A1, it is basically the same as putting avgas into a petrol engine. It burns slightly hotter and doesn't lubricate as much. On a fairly standard motor you can run straight jet A1 with no diesel as long as you use a valve lubricant addative like used in leaded engines for unleaded fuel. Or if you have access to mil spec avtur then you won't need it.
http://www.outerlimits4x4.com/viewtopic ... 6&t=231346j-top paj wrote:gayer than jizz on a beard
It will depend on your engine, later models won't like it, earlier low tech engines will probably tolerate it.
My humvee is ex-USAF so I'd reckon it has spent most of its life running on jetfuel.
Mixing it with diesel would be the go and for peace of mind fit a EGT so you can compare temps with and without jet.
My humvee is ex-USAF so I'd reckon it has spent most of its life running on jetfuel.
Mixing it with diesel would be the go and for peace of mind fit a EGT so you can compare temps with and without jet.
Peter
Dungog NSW
M1026 Humvee , Oka Camper
Dungog NSW
M1026 Humvee , Oka Camper
Road Ranger
post 97 aus diesels should run viton seals and will be ok with avgas ie doesnt need the lubritcity of sulphur. temp is the onl.y thing I can thik of, and the two stock oil thing would probably inhibit the burn and cool it down
If the above post did not offend you in any way please PM me so I can try harder!!
According to my reading currently the cetane spec on diesel fuels is a minimum of 40. There is no minimum spec for Jet A (using ASTM D-1655 specification)
Sounds a bit hit-and-miss, in that if the cetane is higher than 40 you will get more performance but if it is below 40 you wont.
More can be read at :
http://www.generalaviationnews.com/edit ... n&-nothing
Tom Sheppard covers the topic on P26-15 of his excellent book 'Vehicle-dependent Expedition Guide' intended for those who travel to remote locations and may need to try different fuels. He outlines that in Canada, pure Jet-A is run in diesel engines to lower the cloud point (waxing) to -48 deg C.
On page 2.6-16, Tom advocates the use of 'lubricity additives' to compensate for the Jet-A once it exceeds 50%. Apparently some US injector pump maufacturers make 'Arctic' pumps to compensate for low lubricity diesel but Lucas and Bosch do not consider it necessary.
Sounds a bit hit-and-miss, in that if the cetane is higher than 40 you will get more performance but if it is below 40 you wont.
More can be read at :
http://www.generalaviationnews.com/edit ... n&-nothing
Tom Sheppard covers the topic on P26-15 of his excellent book 'Vehicle-dependent Expedition Guide' intended for those who travel to remote locations and may need to try different fuels. He outlines that in Canada, pure Jet-A is run in diesel engines to lower the cloud point (waxing) to -48 deg C.
On page 2.6-16, Tom advocates the use of 'lubricity additives' to compensate for the Jet-A once it exceeds 50%. Apparently some US injector pump maufacturers make 'Arctic' pumps to compensate for low lubricity diesel but Lucas and Bosch do not consider it necessary.
Rod
'85 110, LT-95, 4BE1 Isuzu & Rear Maxi
'85 110, LT-95, 4BE1 Isuzu & Rear Maxi
Avtur and diesel
Have run a mix for years with no problems at all. 50/50 was what I used to run. Get a white spirits drum and take it away. Just don't get caught. Could be deemed as theft as most of the fuel and oil is recycled. But give it a go. Works a treat.. Slight power gain as well.
Custom body work by trees and rocks...
" Where's the party Officer "
Ruff Gq wrote "and i am so stupid that i don't know how it is done."
" Where's the party Officer "
Ruff Gq wrote "and i am so stupid that i don't know how it is done."
avtur
I don't know how u can get a slight power gain 82 lux, It gives about 80% power compared to diesel and runs hotter too. It's dryer so it's good to jam a few hundred mils of oil in per tank too. Why haven't you started yet?
MORE POWER, ARRG ARRG ARRG!
More info ..
In my previous post I referred to Diesel having a Cetane rating of 40. Seems this is for the US. In another post on another Oz forum there is the following quote:
"our cetane number at Mobil refinery is a consistant 52 > 53 leaving the refinery , all the refinerys in Australia run very close specs"
see http://www.aulro.com/modules.php?name=F ... c&start=15
If this is so, it further undermines the possibility of a performance gain from Jet-A
In my previous post I referred to Diesel having a Cetane rating of 40. Seems this is for the US. In another post on another Oz forum there is the following quote:
"our cetane number at Mobil refinery is a consistant 52 > 53 leaving the refinery , all the refinerys in Australia run very close specs"
see http://www.aulro.com/modules.php?name=F ... c&start=15
If this is so, it further undermines the possibility of a performance gain from Jet-A
Rod
'85 110, LT-95, 4BE1 Isuzu & Rear Maxi
'85 110, LT-95, 4BE1 Isuzu & Rear Maxi
Nah wouldnt have been JETA1. Thats the good stuff, that I think most of the world uses comercially. Also most jet/turbo prop A/C use in aus including Mil stuff. But the Yanks (defence) use JP-8 which is a crap fuel. And life spans of every thing that runs on it is reduced. But they can justifie the expanse. Also it helps with logistics. As everything that is supposed to run on Jet fuel or diesel is retuned to run on JP-8. So when they goto war they only need one type of fuel to cater for 90% of there fleet.ozhumvee wrote:It will depend on your engine, later models won't like it, earlier low tech engines will probably tolerate it.
My humvee is ex-USAF so I'd reckon it has spent most of its life running on jetfuel.
Mixing it with diesel would be the go and for peace of mind fit a EGT so you can compare temps with and without jet.
Toughnut maybe able to confirm or deny. Since I think he said he had spent abit of time in Pakistan so may have worked with the US Defence forces.
THOUGHT FOR THE DAY....
Who is online
Users browsing this forum: No registered users and 122 guests