can the center be replaced?
Do i replace the whole front axle?
with the rear i pulled the drums n axle shafts out of the center and undid 12 boltsand yanked her out
i dont understand the gregorys "how to fix it"?
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
MQ welded front
MQ welded front
what is the situation when the welded front goes bang?
can the center be replaced?
Do i replace the whole front axle?
with the rear i pulled the drums n axle shafts out of the center and undid 12 boltsand yanked her out
i dont understand the gregorys "how to fix it"?
can the center be replaced?
Do i replace the whole front axle?
with the rear i pulled the drums n axle shafts out of the center and undid 12 boltsand yanked her out
i dont understand the gregorys "how to fix it"?
MULL
pull the center out and replace it
same pricables as the rear but ya got to pull off a whole lot more
just have a look at it and see what has to come off wheel id probly go as far as taking right back to the swivel and it will have to come out too to get to the axle you will probly need speacil tools for this as well just reading my GQ id say it would be close to the same? as mine the 1988 july GQ so one of the early ones
same pricables as the rear but ya got to pull off a whole lot more
just have a look at it and see what has to come off wheel id probly go as far as taking right back to the swivel and it will have to come out too to get to the axle you will probly need speacil tools for this as well just reading my GQ id say it would be close to the same? as mine the 1988 july GQ so one of the early ones
1995 land rover disco on 265 muddies
Huh? MQ front (C200) is just: drain oil, ~10 bolts out of inspection plate on front of diff, slide axles out and knock centre out (is wedged in between plates). Will be pretty obvious what went bang then, and whether it's worth pulling the ring off the carrier. If the centre, axles and CVs are okay, ask someone else about the pinion...
Sliding the axles out is much harder than the rear, but nothing crazy. I wrote a step by step guide here a while ago which should come up in a search if you care.
Sliding the axles out is much harder than the rear, but nothing crazy. I wrote a step by step guide here a while ago which should come up in a search if you care.
* Nothing is foolproof to a sufficiently talented fool *
well it didnt...Heathx4 wrote: I wrote a step by step guide here a while ago which should come up in a search if you care.
man do i have to quote what words i used aswell?
i ended up searching username and nissan to get:
http://www.outerlimits4x4.com/PHP_Modul ... highlight=
From what i got its the same process as the rear except its wedged into the casing?
i never replaced a front before--Does the center go back inbetween wedges?
MULL
Who is online
Users browsing this forum: No registered users and 3 guests