Maxi Drive Half shafts for my 97 Defender

[tony cordell]

I have read the very intresting thread on the subject below, but I have a couple more questions please:

I currently have the 32inner 24 outer splined CV's and the later narrow hub on my 97 axle can I fit the 110 cv's with the maxi drive halfshafts and drive flanges? into my hubs etc

the set for front and rear over here(uk) cost approx £1000 for 4 shafts 4 drive members plus new cv's so I want to get the right stuff.
Thanks Tony

[Strange Rover]

Im certain that they will fit although I havent done this mod.

A mate of mine ran this setup on a disco front axle (also narrow hub) and he ended up running spacers underneith the drive flanges (cause with the narrow hub the CV stub axle pokes out the end further)

I dont know if this is how Maxi would set it up or my friend origionally had this setup on an early RR axle and then swaped everything onto a disco one.

But either way I think it will fit and the difference will be in the drive flanges (yours will either have to be spaced or new drive flange made up with correct spacing)

Im sure Maxi will know how to do it.

If you dont get a better answer here then I can ring Maxi and ask him (only a local call from here )

Sam

[tony cordell]

I would really appreciate it if you could ask Maxi Drive if this would fit and what part numbers would be required from them, as the supplier over here is a little vague!
I can give the axle number etc as needed.
vin number = salldva67ta>>

[tony cordell]

yes it can be done
and he supplied a list of the required parts to me.
I'll call him again tonight as I forgot to ask a couple of other questions.
Thanks for the reply.
bit of a bind having to wait till Midnight to call though!