I have installed new inner and outer bearings in the rear of my 75 series when re-installing the adjuster not how tight should it be?
Thanx
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
75 Series Rear Hub
Moderators: toaddog, Elmo, DUDELUX
Posts: 2808
Joined: Tue Jul 08, 2003 4:51 pm
Joined: Tue Jul 08, 2003 4:51 pm
Location: NORTH of the black stump.......Townsville
Contact:
torquen up
torque it up til it just starts to thread then back it off 
nar seriously there is a setting in the 75 series work shop manual try done loading it from the net?
nar seriously there is a setting in the 75 series work shop manual try done loading it from the net?:armsup: The Offical Founder of ARMS UP
Jimmy James Beam the III from babinda and mt isa and other places u don't wanna know about :armsup:
www.blackriver4wd.com
Jimmy James Beam the III from babinda and mt isa and other places u don't wanna know about :armsup:
www.blackriver4wd.com
I didn't know there was a place on the net where you could download workshop manuals? Even if I knew the torque spec it would be impossible to set as the nut has 3 studs and uses a Toyota Special Tool. I just thought someone on this board would of changed bearings on a full floating rear and come accross this before.
Posts: 2808
Joined: Tue Jul 08, 2003 4:51 pm
Joined: Tue Jul 08, 2003 4:51 pm
Location: NORTH of the black stump.......Townsville
Contact:
ROCKS HUB
yeah rock there is a special tool for the job i didnt have on so i made one just a little bit of cutting and welding and it works a treat. and its not impossible as the studs have a few lo0cations if you looked in the manual
heres an idea go to the nearest news agent and have a look for the
JUST 4X4S mag have a look through that and you should find a mail order form to order the right cruiser manual itll cost you $40 to $50 max good luck
heres an idea go to the nearest news agent and have a look for the
JUST 4X4S mag have a look through that and you should find a mail order form to order the right cruiser manual itll cost you $40 to $50 max good luck
:armsup: The Offical Founder of ARMS UP
Jimmy James Beam the III from babinda and mt isa and other places u don't wanna know about :armsup:
www.blackriver4wd.com
Jimmy James Beam the III from babinda and mt isa and other places u don't wanna know about :armsup:
www.blackriver4wd.com
Who is online
Users browsing this forum: No registered users and 0 guests