IS THERE A WAY TO RE-CALIBRATE THE SPEEDO ON A RA RODEO
AFTER FITTING BIGGER SIZE TYRES...
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
SPEEDO CALIBRATION
Moderator: Moderators
Utemad wrote:This is the Jaycar unit in my R7 Rodeo.
http://www.outerlimits4x4.com/PHP_Modul ... 484#459484
After 3 diff ratio swaps & 2 correction boxes from Marks Adaptors,I just installed crawler transfer gears & has left me with 7% reduction in final drive (bout 15k's out)
.Now I used my 1st correction box which brought it within 8k's of true. I am wondering whether any soldering/electrical know how is needed with the construction of one of these Jaycar units? Cause I know sweet FA about electrical.
OVERKILL ENGINEERING
www.overkill4x4.com
(02) 94766137
www.overkill4x4.com
(02) 94766137
What vehicle is this for? RA Rodeo?
You do need to be able to build the ciruit board which requires placing the components in their correct position and then soldering them in. To be able to put the components in their correct place you need to knw how to read the colour codes and other info on the side of the individual components (not hard).
However once the kit has been built you need to find your vehicles speed sense wire (follow wires from gearbox vehicle speed sensor) and then perform a few tests on the wire to decide how to tailor the kit to your speed sensor type (kit instructions explain how to do this).
This kit is also able to be customised (using trimpots) so you can adjust your speedo anything from 99% under read to 99% over read.
I think the 31s on my R7 Rodeo equates to 6%. So you will only ever require the one box no matter what tyre/gearing changes you make.
There is a 'How to build kits' pamphlett available from jaycar for first timers.
You do need to be able to build the ciruit board which requires placing the components in their correct position and then soldering them in. To be able to put the components in their correct place you need to knw how to read the colour codes and other info on the side of the individual components (not hard).
However once the kit has been built you need to find your vehicles speed sense wire (follow wires from gearbox vehicle speed sensor) and then perform a few tests on the wire to decide how to tailor the kit to your speed sensor type (kit instructions explain how to do this).
This kit is also able to be customised (using trimpots) so you can adjust your speedo anything from 99% under read to 99% over read.
I think the 31s on my R7 Rodeo equates to 6%. So you will only ever require the one box no matter what tyre/gearing changes you make.
There is a 'How to build kits' pamphlett available from jaycar for first timers.
,I know a few sparkies so I should be able to sort something out......thanx heaps for your info though. 
Who is online
Users browsing this forum: No registered users and 3 guests