Just after advise on cutting arb duluxe bar to suit 2 inch body lift on GQ
Where to cut for best result and strenghth. Just can't find thread on this.
As much detail as possible. Cheers Dorza
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Help on cutting bar!
remove bar measure from bolt hole on car to end of chassey then add 10 mm mark bull bar then cut bar. don"t foget to cut flat bar thickness off bull bar . use flat bar and weld on to bar (i used 25 mm thick but have seen 20 mm used )with exss hanging down same hight as body lift plus about 10 mm for good weld lift in to place and weld on to mount pices witch u will have bolted back onto car ( don't foget to disconnect battery on car befor welding ) 
Who is online
Users browsing this forum: No registered users and 32 guests