GQ rear arm trailing bushes pipe size

Post by **ludacris** » Mon Mar 06, 2006 6:21 pm

Does any body have the pipe size for the rear GQ trailing arm bushes. Making up a set of my own.

LudaCris

Post by **YankeeDave** » Mon Mar 06, 2006 7:11 pm

50NBXH
thats 50 nominial bore extra heavy wall
then just turn in down a bit (the ID), will check the measurment again at work tomorrow

Post by **Slunnie** » Mon Mar 06, 2006 9:44 pm

You can also buy them pretty cheap made with high carbon steel and CNC machined by 3rds Productions. I think I paid about $20-25 for the ring and bush. Not bad when most people charge about $25 for the bush only.

Post by **YankeeDave** » Tue Mar 07, 2006 8:26 am

ok found the drawing, 50NBXH pipe and then turn down the ID to
49.8 +0 -0.5

That was perfect for me, and genuine bushes pressed in great.

Post by **ludacris** » Tue Mar 07, 2006 8:27 am

Cheers for that.

LudaCris

Post by **YankeeDave** » Tue Mar 07, 2006 8:30 am

dont forget to put a small chamfer on the edges so the bush goes in easier

Post by **Slunnie** » Tue Mar 07, 2006 8:30 am

YankeeDave wrote:ok found the drawing, 50NBXH pipe and then turn down the ID to
49.8 +0 -0.5

That was perfect for me, and genuine bushes pressed in great.

Will the bush press in at -0.5?

Post by **YankeeDave** » Tue Mar 07, 2006 9:07 am

ohh glad you picked that up, was a typo

it should be -0.05

Outer Limits 4x4 Board

GQ rear arm trailing bushes pipe size

GQ rear arm trailing bushes pipe size

Who is online