Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

LH M23x1.5mm Taps needed in Sydney.

General Tech Talk

Moderators: toaddog, TWISTY, V8Patrol, Moderators

Forum rules
Post Reply
Posts: 3349
Joined: Tue Nov 23, 2004 10:29 am
Location: Not where you are

Contact:
Contact Gribble

LH M23x1.5mm Taps needed in Sydney.

Post by Gribble »

Does anyone on in sydney have this size in LH and RH thread, taper and bottom tap that i can borrow for a weekend?

If you do have them, PM me and we can arrage a deal to rent them for 2 days.

Thanks! :D
\m/
Top
Posts: 275
Joined: Wed Aug 27, 2003 7:21 pm
Location: sunny melbourne

Post by 85lux »

i looked into these for tapping 80series rod end threads. i was told they would have to be custon ground (P&N or Sutton). super expensive. i just screw cut the threads in the end. Maybe there is an auto tools joint that does them. If you or your mates can competently use a lathe it is easy.
Top
Post Reply

Return to “General Tech”

Who is online

Users browsing this forum: No registered users and 3 guests