just chucked some 2 inch blocks under my 80 and i was thinking
what to do with the gear levers. on my old 80 i heated them up and bent them so they would clear the floor but what has anyone else done different?
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
80 series bodylift
Moderators: toaddog, Elmo, DUDELUX
80 series bodylift
nissans die young, toyotas go on for ever.
80 body lift
heat it up with the oxy & bend I think thats the only way.
current truck, 105 series GXL diesel 6" springs & twin pro lockers
sierra LWB spoa one wide track diffs twin locked
Sierra Parts Wanted pm me
sierra LWB spoa one wide track diffs twin locked
Sierra Parts Wanted pm me
Its a good idea to pack wet rags around the base of the gear lever also. Otherwise you can perish the inner bushes that stop vibration from the road been transfered to your hands. Slowly and carefully is the way, dont overheat it.
|^^^^^^^^^^^^^^| ||
|.........SUZUKI..........| ||'|";, ____.
|_..._..._______===|=||_|__|..., ]
(@)'(@)"""''"**|(@)(@)*****''(@)
|.........SUZUKI..........| ||'|";, ____.
|_..._..._______===|=||_|__|..., ]
(@)'(@)"""''"**|(@)(@)*****''(@)
Hi
Every time I see a body lift topic come up I mean to ask this.
What have other people done where the steering shaft goes through the fire wall?
Mine rubed after the lift.
Have you had this problem Hackas?
I grinded it but I think this was a bit rough and quick. I now have an elongated hole and the rubber seal dose not cover this.
The bit I grinded is a plate that screws into the firewall. I probably could have tried to move this up and try screwing it in a diferent position.
But did not have time.
What have other people done?
Burnsy
Every time I see a body lift topic come up I mean to ask this.
What have other people done where the steering shaft goes through the fire wall?
Mine rubed after the lift.
Have you had this problem Hackas?
I grinded it but I think this was a bit rough and quick. I now have an elongated hole and the rubber seal dose not cover this.
The bit I grinded is a plate that screws into the firewall. I probably could have tried to move this up and try screwing it in a diferent position.
But did not have time.
What have other people done?
Burnsy
Thats what i didbruiser wrote:I probably could have tried to move this up and try screwing it in a diferent position. But did not have time. What have other people done?
And i just covered the gap at the bottom with silicon, it was the quickest and easiest thing to do at the time.www.bolsys.com.au
Who is online
Users browsing this forum: No registered users and 11 guests